I have a 60GB Corsiar ForceGT SSD as boot drive.
Old setup: AMD 1090T/M4A87TD EVO, the WEI gave it 7.9.
New setup: Intel 3570K/MSI Z77A-G45, WEI now gives it 5.9
When setting it up in my new system, I made sure it was attached to a 6GB Sata port, AHCI was set in UEFI and trim was enabled . I know WEI is far from being the be all and end all of benchmarks, but I cant figure out why this has happened. Am I missing something obvious.
I would re check bios to make sure
even when you installed in Achi could have went back to IDE and lowered the score
well unless it is the firmware there shouldn't be that much of a degration of that drive
Maybe it is failing you could try running SSDmark or some software like that to see if the read and write are on par with what it is supposed to be if not maybe it needs to be re aligned and that could be the issue
As another suggestion, try running the WEI disk from command prompt to give you not only just the score, but also detailed results such as sequential speed etc. To do this, just run CMD.exe as administrator then type without quotes "winsat disk -v".
Another thing is that you have all the right setup for your SSD (TRIM, AHCI, SATA III port etc.), but your SSD might be running in SATA II mode (this isn't likely to happen though). To check, download crystal disk info and this utility shows you the SMART data from your SSD as well as if SSD is running on SATA II or III or if TRIM is really enabled, etc.
Here's Brink's download link for Crystal Disk Info:
Source: FREE Great Programs for Windows 7 [2]
This may be coincidence. I moved swap file to another drive and disabled hibernation and system restore. I re-ran WEI and got a figure of 7.8. So thanks for the suggestions and help, greatly appreciated.
Quote