Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Question about CHKDSK

10 Nov 2013   #1
herbc

win 7 64 Home edition
 
 
Question about CHKDSK

Hi folks , my question is when i run "chkdsk" in normal mode it says no problems but when i run it in safe mode it says errors were found and to do a "chkdsk" with the designation F for fix .

I can never do it right then because it says another process is using it but it says do you want to schedule a check upon restarting your computer which it does.

However this seems to be a re occuring issue and a week later it will say errors in safe mode again.

Any advice would be highly appreciated.


My System SpecsSystem Spec
.
10 Nov 2013   #2
richc46

Microsoft Community Contributor Award Recipient

Windows 10, Home Clean Install
 
 

First view the results in normal and safe mode
Check Disk (chkdsk) - Read Event Viewer Log
That may explain the problem
My System SpecsSystem Spec
Reply

 Question about CHKDSK




Thread Tools




Similar help and support threads
Thread Forum
CHKDSK question
I have tried running chkdsk /f /r from command prompt and access is denied because of insufficient privilege - "you have to invoke this utility runnning in elevated mode." Can someone explain what this all means and how to go about running chkdsk /f /r? TIA Frank
Performance & Maintenance
Chkdsk question
I got a pop-up on screen yesterday that said the drive had been disconnected. I re-booted and the drive was there and operating normally. I ran a Chkdsk over-night and it said "No problems". I ran a Seagate Tools(Long Generic test) and it said failed. I opened Acronis Drive Monitor and...
Hardware & Devices
chkdsk question
I have a Windows 7 computer which can't be started in normal or safe modes and would like to run chkdsk. I can use the installation disc to get to the System Recovery Options and use Command Prompt to run chkdsk c: /r, but I get the message "CHKDSK cannot be run because it is in use by another...
Performance & Maintenance
chkdsk c: /f /r question
evening all, I need to perform the above chkdsk c: /f /r command on my windows 7 system disk. when i run this in a cmd window i get the following message(see attached screenshot). If I continue to run this command, will the full dskchk line complete with the switches "/f /r" be actioned, or just...
Performance & Maintenance
ChkDsk safety question
Hi, Several years ago, my old XPh system began behaving erratically. I finally decided to run chkdsk on the C drive, which I did from the command line, with the Repair switch. Chkdsk indeed found disk errors, and I watched in horror as it began disallocating sector after sector. A huge...
Performance & Maintenance


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 18:01.
Twitter Facebook Google+