Show Us Your WEI

here's mine

bloke said:

i think it should be a drive of the same age as the system it should.

Drives from 01, systems from 01.. I'm talking Xbox classic here

Weridly enough, today i did a clean install from 7048x64 to 7077x64 and now my score has changed. very strange....

bloke said:

LMAO!! Monga is protective of the Cake is he yes? the WEI is based on the actual grfx card, not the speeds, i think if i overclock the crap out of my 98gx2's i get an extra .1 point...wow. and the cake goes to a legitimate old school system, but in particular needs a low hdd score... not a score of 4. lol

Eh, I can raise the score by .5+ by overclocking,just can't lower it by underclocking.

Wasn't sure where to post this as it involves Windows 7 , but involves OC question on X58, and memory ? as well

OK we all know that WEI is not a bench mark, and not the best way to mesure a system, That being said , I was still trying to get all 7.9's mainly because I read a post from microsoft that said it could not be done at this time.

Any way I had an X58 I-7 965 OC to 4.0 with 2 295's in it and 2 ocz SSD's I was getting
Processer 7.6
Memmory 7.8
Aero graphics 7.9
3D graphics 6.6
Disk performance 7.5
for a system WEI score of 6.6

I decided to add 6 more GB MEM, and another SSD hard drive, thinking it would take my memory and disk speed up, the extra 6 gig changed my memory timeing from T1 to T2, while it did increse my
Mem score from 7.8 to 7.9
my 3D Graphics DROPED from 6.6 TO 6.0
And despite adding a third SSD In RAID 0 my score DROPED from 7.5 to 6.7
so my score is now 6.0

Should adding memory caused that much of a decrese, or was it something else, I expected my Disk scores to go up, by almost as much as they went down, and 3D graphics has me baffled I've removed and reloaded drivers 4 times.

Tomorow I am going to remove the extra Mem and see if my scores go back up, But I wanted to see if this sounded reasionable to any of you out there with more experiance in this.

I've Over clocked as much as my chip will let me, my temps arn't bad, but a bump in QPI causes Bluescreen, and a bump in clock ratio causes a dump in windows.

What am I missing? and does this information sound normal?

My profile was:
Mother Board ( EVGA X58 X3 SLI ) http://www.overclockersclub.com/reviews/evga_x58_sli/
Case ( CoolerMaster 932 HAF) http://www.coolermaster.com/products/product.php?act=detail&id=5363
Drivers (182.50 )
Bios ( SZ21Z )
CPU ( 965 ) http://i4memory.com/f55/intel-core-i7-920-940-965ee-nehalem-online-reviews-list-11131/
CPU Cooler ( V8 ) http://www.coolermaster.com/products/product.php?language=en&act=detail&id=5279
Memory ( Patriot Viper Series 9,9,9,24 6gb kit) http://www.overclockersclub.com/reviews/patriot_viper_tri/
PSU ( Corsair HX100W ) http://www.hardwaresecrets.com/article/484/1
GPU ( two 295+ ) http://www.nvnews.net/reviews/evga_geforce_gtx_295/index.shtml
2 SEAGATE SATA III 1TB RAID-0 , http://www.newegg.com/Product/Product.aspx?Item=N82E16822148274

2 OCZ vertex SSD's 30 MB (raid-0 3rd added 4-21)
Operating System ( Vista x64 Win 7 Beta 7.000 x64)
Display:LG http://www.tigerdirect.com/applications/searchtools/item-details.asp?EdpNo=3920245&csid=_21

Frequency Control
CPU Clock Ratio ( 25X )
CPU Host Frequency (Mhz) ( 160 )
MCH Strap ( Auto )
CPU Uncore Frequency (Mhz) ( Auto )
Spread Spectrum ( Disabled )
PCIE Frequency (Mhz) ( 100 )


Memory Feature
Memory Control Setting (Enabled )
Memory Frequency ( 2:10 )
Channel Interleave Setting ( 6 Way )
Rank Interleave Setting ( 4 Way )
Memory Low Gap ( Auto )
tCL Setting ( 9 )

tRCD Setting ( 9 )
tRP Setting ( 9 )
tRAS Setting ( 24 )
tRFC Setting ( 88 )
Command Rate ( T1) T2 with 12G 6X2


Voltage Control
EVGA VDroop Control ( With VDroop )
CPU VCore ( 1.375v )
CPU VTT Voltage ( +250 )
CPU PLL VCore ( 1.8 )
DIMM Voltage ( 1.625v )
DIMM DQ Vref ( +0 )
QPI PLL VCore ( 1.35v )
IOH VCore ( 1.25 )
IOH/ICH I/O Voltage ( 1.50 )
ICH VCore ( 1.05 )
PWM Frequency ( 800 )


CPU Feature
Intel SpeedStep ( Disabled )
Turbo Mode Function ( Disabled )
CxE Function ( Disabled )
Execute Disable Bit ( Enabled )
Virtualization Technology ( Disabled )
Intel HT Technology ( Enabled )
Active Processor Cores ( All )
QPI Control Settings ( Enabled )
QPI Link Fast Mode ( Enabled )
QPI Frequency Selection ( 6.4 )

3DMARK Vantage P35890 GPU 32644 CPU 51144
CPUZ Validation: http://valid.canardpc.com/show_oc.php?id=538451

Is there any program to show your WEI for XP ?















Please don't laugh!

KMoore4318 said:

Wasn't sure where to post this as it involves Windows 7 , but involves OC question on X58, and memory ? as well

OK we all know that WEI is not a bench mark, and not the best way to mesure a system, That being said , I was still trying to get all 7.9's mainly because I read a post from microsoft that said it could not be done at this time.

Any way I had an X58 I-7 965 OC to 4.0 with 2 295's in it and 2 ocz SSD's I was getting
Processer 7.6
Memmory 7.8
Aero graphics 7.9
3D graphics 6.6
Disk performance 7.5
for a system WEI score of 6.6

I decided to add 6 more GB MEM, and another SSD hard drive, thinking it would take my memory and disk speed up, the extra 6 gig changed my memory timeing from T1 to T2, while it did increse my
Mem score from 7.8 to 7.9
my 3D Graphics DROPED from 6.6 TO 6.0
And despite adding a third SSD In RAID 0 my score DROPED from 7.5 to 6.7
so my score is now 6.0

Should adding memory caused that much of a decrese, or was it something else, I expected my Disk scores to go up, by almost as much as they went down, and 3D graphics has me baffled I've removed and reloaded drivers 4 times.

Tomorow I am going to remove the extra Mem and see if my scores go back up, But I wanted to see if this sounded reasionable to any of you out there with more experiance in this.

I've Over clocked as much as my chip will let me, my temps arn't bad, but a bump in QPI causes Bluescreen, and a bump in clock ratio causes a dump in windows.

What am I missing? and does this information sound normal?

My profile was:
Mother Board ( EVGA X58 X3 SLI ) http://www.overclockersclub.com/reviews/evga_x58_sli/
Case ( CoolerMaster 932 HAF) http://www.coolermaster.com/products/product.php?act=detail&id=5363
Drivers (182.50 )
Bios ( SZ21Z )
CPU ( 965 ) http://i4memory.com/f55/intel-core-i7-920-940-965ee-nehalem-online-reviews-list-11131/
CPU Cooler ( V8 ) http://www.coolermaster.com/products/product.php?language=en&act=detail&id=5279
Memory ( Patriot Viper Series 9,9,9,24 6gb kit) http://www.overclockersclub.com/reviews/patriot_viper_tri/
PSU ( Corsair HX100W ) http://www.hardwaresecrets.com/article/484/1
GPU ( two 295+ ) http://www.nvnews.net/reviews/evga_geforce_gtx_295/index.shtml
2 SEAGATE SATA III 1TB RAID-0 , http://www.newegg.com/Product/Product.aspx?Item=N82E16822148274

2 OCZ vertex SSD's 30 MB (raid-0 3rd added 4-21)
Operating System ( Vista x64 Win 7 Beta 7.000 x64)
Display:LG http://www.tigerdirect.com/applications/searchtools/item-details.asp?EdpNo=3920245&csid=_21

Frequency Control
CPU Clock Ratio ( 25X )
CPU Host Frequency (Mhz) ( 160 )
MCH Strap ( Auto )
CPU Uncore Frequency (Mhz) ( Auto )
Spread Spectrum ( Disabled )
PCIE Frequency (Mhz) ( 100 )


Memory Feature
Memory Control Setting (Enabled )
Memory Frequency ( 2:10 )
Channel Interleave Setting ( 6 Way )
Rank Interleave Setting ( 4 Way )
Memory Low Gap ( Auto )
tCL Setting ( 9 )

tRCD Setting ( 9 )
tRP Setting ( 9 )
tRAS Setting ( 24 )
tRFC Setting ( 88 )
Command Rate ( T1) T2 with 12G 6X2


Voltage Control
EVGA VDroop Control ( With VDroop )
CPU VCore ( 1.375v )
CPU VTT Voltage ( +250 )
CPU PLL VCore ( 1.8 )
DIMM Voltage ( 1.625v )
DIMM DQ Vref ( +0 )
QPI PLL VCore ( 1.35v )
IOH VCore ( 1.25 )
IOH/ICH I/O Voltage ( 1.50 )
ICH VCore ( 1.05 )
PWM Frequency ( 800 )


CPU Feature
Intel SpeedStep ( Disabled )
Turbo Mode Function ( Disabled )
CxE Function ( Disabled )
Execute Disable Bit ( Enabled )
Virtualization Technology ( Disabled )
Intel HT Technology ( Enabled )
Active Processor Cores ( All )
QPI Control Settings ( Enabled )
QPI Link Fast Mode ( Enabled )
QPI Frequency Selection ( 6.4 )

3DMARK Vantage P35890 GPU 32644 CPU 51144
CPUZ Validation: http://valid.canardpc.com/show_oc.php?id=538451

Can you post your raw benchmark scores by going to C:\Windows\Performance\WinSAT\DataStore and then going to the most recent formal assessment?

If your raw numbers are going up but the subscore is going down, that is weird.