New
#1
Did somthing stupid and can't get to bios to fix it
I tried to overclock with bad results.
For starters I really should have been doing this b/c I don't know what I'm doing but you have to learn somehow.
Here is what I know,
I was playing with the CIA 2 and had it on Sport with no problems. It was showing about 3.6GHz and stable with Prime95 for a few hours so...
I tried Full Thrust and it would not boot. This is where I think I messed up.
I changed the CPU Voltage control to 1.35v and left everything else the same and tried Racing. It booted for about a minute then blue screened and I shut down. Now it won't even boot long enough to let me bring up the bios. It starts then shuts down after about 2 seconds.
I think everything in my bios is set up standard.
I know this is vague but its all i got
If I could just get back into the bioS I could change it. Unless something terminal is going on.
Thanks for you help if you can
Don
As best I remember here is how MB Intelligent
GIGABYTE GA X48T DQ6 Clock Settings
MB Intelligent Tweaker (MIT)
Robust Graphics Booster...........:Auto
CPU Clock Ratio...................: 9.5
CPU Frequency.....................: 333Mhz
CPU Host Clock Control............: disabled
CPU Host Frequency(Mhz)...........: 400
PCI Express Frequency (Mhz).......: Auto
C.I.A.2...........................: enabled
Performance Enhance...............: Racing
System Memory Multiplier (SPD)....: 3.33D
Memory Frequency(Mhz).............: 800Mhz
DRAM Timing Selectable ...........: Manual
Standard Timing Control
CAS Latency Time (tCL)............: 4
DRAM RAS# to CAS# (tRCD).........: 4
DRAM RAS# Precharge (tRP).........: 4
Precharge Delay (tRAS)............: 12
...
CPU Voltage Control...............: 1.35v
Normal CPU Vcore..................: 1.1125v