New
#1
Bitlocker: BitLocker could not be enabled
I am trying to enable BitLocker on a Windows 7 Ultimate x32 system with TPM. I follow the Wizard and when asked to encrypt the drive I select 'Run BitLocker system check' and 'Continue' (see attached sreenshot).
The USB is inserted and contains the recovery key (.txt and .tpm). During reboot I get:
Windows BitLocker Drive Encryption Information
The system boot information has changed since BitLocker was enabled.
You must supply a BitLocker recovery password to start this system.
Confirm that the boot changes to this system are authorized.
If the changes to the boot system are trusted, then disable and re-enable
BitLocker. This will reset BitLocker to use the new boot information.
Otherwise, restore the system boot information.
ENTER=Continue
Windows then continues to start normally. After login I get an error message: BitLocker could not be enabled (see attached screenshot).
When I check TMP it shows as active, initialized and owned.
I've started out from scratch several times - same results. I can't figure out what the problem is.
This is driving me nuts.
Any help appreciated
Thanks