New
#81
please come and try to help me! my post is entitled 'please help me' the matter is urgent!
please come and try to help me! my post is entitled 'please help me' the matter is urgent!
In RAID mode the data is spread over both drives that is why it shows up as a single drive. If your PSU was bad it would be more likely to crash with just one power lead to both drives. with separate cables you are using two power rails which should be easier on the PSU.
I think it may be possible that the RAM is underpowered I need to chase this up and I will get back to you.
All of the drivers are up to date, I've ran Memtest, and I've tested the HDDs. All is well, according to the computer. If all is not well, the computer isn't telling me. Well, okay, it's telling me, but it isn't telling me ENOUGH.
Well, I actually, honestly believe my system, before the motherboard shorted out, had problems for different reasons. Some of my drivers were outdated at the time, including my RAID, chipset, and graphics. However, the fact that my own RAM doesn't work in his machine is unsettling and disturbing. If I have to RMA two sets of RAM, I'm probably going to rage out. I've already been waiting over a month for my new motherboard.I do find it strange that you built 2 identical machines and they are both unstable. You do get bad parts occasionally but 2 at the same time is strange. At this point the machine is not stable enough to run prime95 (CPU test). The only thing I can suggest is to start checking components 1 at a time, and also go back through the machine and make sure all wiring is securely connected, there are no frayed wires, and all connections are properly connected. There does seem to be something about the CD/DVD player. Correct me if I am wrong, but you have at least booted with it disconnected. If that continues I would suggest another Cd/DVD player. It is the cheapest component in the machine. It at least makes me think it is a contributer to the problem. Keep us advised of your progress.
I've checked all of the connections and there isn't anything wrong with them. The wires are fine and the connections are secure. Right now I do have the optical drive unplugged while I have the single RAM stick in and the computer is running top notch at the moment. I was able to boot and the system never crashed. What I plan to do is start the computer up a few more times with the single RAM stick and the optical drive unplugged. If it continues to be stable, I'm plugging the optical drive back in to the PSU. If it continues to be stable, I'll try again to boot from the other stick that the system crashed with, and if it crashes again, with or without the optical drive plugged in, I'll have to assume it's the stick of RAM that was in the second DIMM slot.
Right now, software isn't telling me a goddamn thing, and it hasn't been for months. I have to rely on the OS responding to the hardware moving around.
Look at the stick of ram you are running and tell me what the voltage, timings and frequency are. Also if you could, post a screenshot with CPUz, of the Memory tab, spd tab and cpu tab. Go into bios and make sure dram voltage is set exactly what it says on the stick of ram. Bios will automatically at default set your timings at 9-9-9-24. Lets see if the voltage could be at least part of the problem.
I haven't gone into BIOS yet, but I figured I'd update before I do all of that.
I tried booting the system five times with the single stick of RAM. It booted cleanly four times. On the fifth, it crashed to a Fatal System Error. This was with the optical drive still unplugged.
Whatever the problem is, apparently it has to do a lot with RAM. I had a little bit of trouble booting after it crashed, even with the one stick.
I'll go to the BIOS and have a look.