Kernel-Power 41 18 Times Last 7 Days

Thank you!

Attachment 199336

Attachment 199337


Kernal - Power 41 is back.

I've attached the latest reports for you review. Please let me know if something stands out.

Thank you!

Problem Devices:

Code:

High Definition Audio Device	HDAUDIO\FUNC_01&VEN_1002&DEV_AA01&SUBSYS_00AA0100&REV_1002\5&B219905&0&0001	This device is disabled.
BlackBerry			USB\VID_0FCA&PID_8004&MI_00\7&DECD26&0&0000					The drivers for this device are not installed.

Do the following steps to check hardware.

• Download and install the appropriate version of HWINFO: HWiNFO32 for 32-bit Windows 7 or HWiNFO64 for 64-bit Windows 7 to check hardware temperatures by running in sensor-only mode. Start logging the temperature through sensor-only mode when the computer first starts, and let it run during stress or until a crash occurs.
  
  Save the CSV file in a place you will remember, and then compress the CSV file to a zip file and upload to here for us to analyze by following the steps in Screenshots and Files - Upload and Post in Seven Forums.
  
  
  
• Use FurMark: VGA Stress Test, Graphics Card and GPU Stability Test, Burn-in Test, OpenGL Benchmark and GPU Temperature | oZone3D.Net to test the graphics card GPU. Then use the |MG| Video Memory Stress Test 1.7.116 Download to test your graphics card memory.
  
  
  
• Run Hardware - Stress Test With Prime95 to determine any hardware problems. Run all three tests for a few hours each. If you get errors, stop the test and post back here.
  
  
  
• Run the boot version of Memtest86+ paying close attention to Parts 2 and 3 of the tutorial. Also, in case Memtest86+ misses anything and comes up with no errors, run the extended version of the Windows Memory Diagnostics Tool for at least five passes. These you may want to run overnight since they take a long time to complete (run them an hour before bed each of the next two nights and check before going to sleep that they are still running).
  
  If you swap any memory components, follow these steps for ESD safety:
  
  1. Shut down and turn off your computer.
  2. Unplug all power supplies to the computer (AC Power then battery for laptops, AC power for desktops)
  3. Hold down the power button for 30 seconds to close the circuit and ensure all power drains from components.
  4. Make sure you are grounded by using proper grounding techniques, i.e. work on an anti-static workbench, anti-static desk, or an anti-static pad. Hold something metallic while touching it to the anti-static surface, or use an anti-static wristband to attach to the anti-static material while working.
  
  Once these steps have been followed, it is safe to remove and replace components within your computer.

1600 frequency memory is known to have problems with AMD processors, so setting it to 1333 would be better. You also have a lot of memory installed, and the BIOS regulates voltages for 4 GB or less in Auto mode.

Download and install CPU-Z and Upload screenshots of the CPU, Mainboard, Memory, and SPD tabs. In the SPD tab, upload an image of each slot.

Also, go into your BIOS and post all Voltages (CPU, RAM, NB, IMC, etc.) and all RAM settings (timings, frequency, etc.)

Thanks to Dave76 for help learning RAM Stability