New
#21
OK, here is cpuid all tabs with info open. I think it's the board that's restricting the memory .
OK, here is cpuid all tabs with info open. I think it's the board that's restricting the memory .
your ram is running in single channel mode that's why
check your ram slots you got them in the wrong order it's easy to do just consult your MB manual and make sure you get them in the dual channel mode
Your CPU voltage is low also stock is 1.3V you are showing just barely a little over 1 volt you need to check all your hardware and make sure your voltages are correct the motherboard does not always set the proper voltages like i said your ram voltage was a little low also
max volts on that CPU would be like 1.5 also you can unlock the other core on that and have a quad core also it overclocks fairly well
I have the ram in channel a according to the motherboard, it shows in order from left to right on the board, a2|b2|a1|b1, and my ram is in a2 and a1, i also had it in their before at a2 and b2 before i consulted the mb manual which was wrong. the manual says channel a and channel b so i have the ram in their correctly now but i didn't before. i'll try the cpu voltage thing that might help a lot though. Thanks
well something is off with the ram for sure CPUZ says it's running in single channel mode
oh i get it now lol duh sorry DUAL channel compared to single channel
so how do i overclock the processor to unlock the fourth core?
go by the marks on the board for ram placement i have seen the manual be wrong i just always consult the manual first they make it kinda tricky if your not paying attention