Problem Of connection over LAN.

What do you mean by checking the cable??? Only way is to replace the cable, but keeping in mind 60mtr makes it impossible. Also, I dont think a cable can cause the speed issue.

dre@ms said:

What do you mean by checking the cable??? Only way is to replace the cable, but keeping in mind 60mtr makes it impossible. Also, I dont think a cable can cause the speed issue.

Oh yes cable can make a huge difference. Here is a test you can do get a 9v battery, a light bulb and a 3 meter wire. Make sure the bulb works and connecting it directly to the battery with short wires everything works note how bright the bulb is. Next connect the battery on one end of the 3 meter wire and a light bulb on the other. Look at the bulb see how bright it is. Next get a 15 meter cable and do the same thing. The bulb may not be very bright or off completely. This is a very basic example of how cabling does make a difference. Then there are issues with ends, kinks in the wire, how close it is to electric sources, heat, moisture, etc. etc.

Dear Sirs,

Thank you very much for your guide lines. I have purchase Ethernet 4 pair cable after your said cable test.Its true that My old cable was create problem. Now, one wire of orange pair make fluctuating of lamp working. I have lay down new cable and connect with same existing router port. Now my PC connect on 100mbps speed. you can check results in attach image.

Dear all experts, Now I have rich on 100mbps speed but not 1gbps ,Kindly guide me how to access this speed.

Once again lot of thank because I have lot of learn knowledge form this forum.

Does your HUB or Switch or Router support 1GB? If not 100meg may be as fast as you can go. Did you buy a CAT 5e or CAT 6 cable? Those cables are certified for 1GB anything less is not. (Even though they may run at 1GB they are not certified and you may have problems) The larger number the better so if you bought CAT 7 you are fine.

Dear Sir,

I have purchase CAT6, 4 UTP cable in blue color.Sir Please guide me, how to test or check my router can work or support on 1Gbps??.
We are using Cisco Catalyst 2960 series switch.

Unless your 2960 switch is a G series (most are not) you will only connect at 100meg. G series switches are very expensive and most mid-size or enterprise companies don't buy them.

ex: 2960G-24

Sir,

Its true, we are using 2960G-24 model switch.Now plz tell me how can gain full speed advantages of our above mention switch.

arshadmahmood said:

Sir,

Its true, we are using 2960G-24 model switch.Now plz tell me how can gain full speed advantages of our above mention switch.

If you plug your computer into the switch and any other device that has a 1Gb card or support you should connect at 1Gb.

What happens when you connect the newly purchased cable from the computer to the switch do you get 1Gb? If you do then you know your switch is working, cable is good, and your NIC on your computer is setup for 1Gb. If you are trying to get your ROUTER to connect at 1Gb you may not be able to. Many routers only support 100meg. What is the model number of the router?

Sir,
When I connect my new cable plug into my pc then my computer task bar saying that my pc connect with LAN then i check my network controller speed configuration.it was on auto and lan was connected on 100mbps.I search 1Gbps option but there is no any option of 1Gbps.

Sir, In our office 18 computer connected with 2960G-24 this switch.one fiber optic cable comming from 1 km away and connect with this switch.I dont know which router is running back side.

Try updating your network card driver:
Drivers & Downloads