Same think like 3-4 hours ago.
I can't boot with AHCI. I went to BIOS, i changed like here:
"SATA RAID AHCI Mode : i put AHCI now.
Then i have SATA PORT 0-3 Native Mode : i enabled it
And down i have Onboard SATA / IDE Ctrl Mode : i put it on IDE"
But still cannot boot with AHCI.
I don't understand why happent this, after recovering the backup image.
:)
Now, even if i go into BIOS to change like i did 1 hour ago, i cannot boot with AHCI.
That's very annoying
Go back and look at post 98. That is the way bios was set up when it worked right. Other than that, I don't know what you did to fix it last time.
An image is a picture in time. It will restore to exactly what the image was at the time it was taken. Every time you restore that image you will get the same result. If you had not turned off restore you could resore back to before you restored the Acronis image. Go through this tutorial and try it. It works. I have done it several times. There is also a tutorial on imaging with Free Macrium which is quite popular here and is very simple. It was done by WHS. I don't know what else to tell you, as I don't know how you fixed it last time. Go back over your steps.
This picture was just an example like my BIOS looks
Now i went back to BIOS, modified like post 98 and i was able now to boot with AHCI.
I don't understand. Same settings, 20 minutes ago i couldn't
I think i re-install Windows again and i leave alone the hotswap icon.
But i'm affraid there is some problems between Acronis - SSD - HDD - 100 MB system reserved
Quote