acpi.sys 0xc0000098

[fckool]

Hi,

First off all, the first error I had was about ntoskrnl.exe, I replaced it then I get a new one: hal.dll, I replaced it too, then I get the acpi.sys error with the path (C:\Windows\System32\Drivers\acpi.sys.

When I replaced this one, I get finally this error and I'm stuck:

What I did so far:

• Chkdsk /R /F
• Rebuild BCD (All kind, bootsect /nt60 ..., bootrec /fixboot & fixmbr, I also writed all the boot with bcdedit)
• Replace files like (ntoskrnl.exe, hal.dll, acpi.sys, msisadrv.sys, pci.sys, volmgr.sys, volsnap.sys and disk.sys)
• Antivírus check, malwarebytes and spyboot check.
• SFC /scannow with and without OFFDIR.

I think I did some more things that I can't remember now.

One week is passed and I spent about 20h trying to resolve this issue.

Any sugestion? Thank you

 

[axe0]

Hi fckool,

Welcome to the 7forums.

Please test your hard drive, this can be done offline (outside of Windows)

Diagnostics Test

 HDD TEST

Run SeaTools to check the integrity of your HDD. http://www.sevenforums.com/tutorials/313457-seatools-dos-windows-how-use.html

   Note

Do not run SeaTools on an SSD as the results will be invalid.

Run chkdsk http://www.sevenforums.com/tutorials/433-disk-check.html

 

[fckool]

Thank you axe0, My disk is not a Seagate, If I try to run SeaTools for Windows on my other Windows partition, it doesn't detect any disk. If I run SeaTools for DOS it will work?

 

[axe0]

It should work yes.

 

[fckool]

The test gives: 100% passed.

I also did several chkdsk before also without problems / bad sectors.

 

[axe0]

Other then a re-installation I cannot think of another possible solution.

What does sfc say when you run it?

 

[fckool]

Hi,

I got this:

I attached the log, I can't see any error. The Windows drive that I'm trying to recover is D:

 

[axe0]

Please try sfc, reboot, sfc.

SFC need to say "Windows Resource Protection did not find any integrity violation" so no corruption is there.

 

[fckool]

Please try sfc, reboot, sfc.

SFC need to say "Windows Resource Protection did not find any integrity violation" so no corruption is there.

I did that. It gives me now that message. When I try to boot in my win7 I get the same error.

 

[axe0]

Try following

Boot into Windows 7 DVD System Recovery Options or Windows 7 System Repair Disk to Mark Win7 or it's 100mb System Reserved Partition (preferred if you have it) Active.

Then run Startup Repair - Run up to 3 Separate Times until Windows 7 starts and it's boot partition holds the System Active flags.

If this fails when System Reserved partition is marked Active, move the Active flag to Win7 partition itself and then try the 3 repairs again.

Be aware that sometimes GRUB can corrupt Windows 7 beyond repair when on the same HD. If problems persist I would delete it completely and then for any future Linux Dual Boots use separate HD's booted only via BIOS, or Dual Boot - Windows 7 and Linux - Windows 7 Forums.

If all else fails it may be necessary to wipe the boot sector of interfering code using Diskpart Clean Command before Clean Reinstall - Factory OEM Windows 7 which steps are same for retail.

 

[fckool]

The problem is solved.

I get another windows 7 installation media and I replace again the ACPI.sys, after that I replaced more 7 or 8 files *.sys. After all replaces the windows rebooted correctly.

Thank you for your help.