BCCode: 1e --> Please help!

[wolfone]

Hello. Noob here. Just bought a New computer and I'm getting a blue screen of death (BCCode: 1e) each time I close down. Please see system details below and attached file with error details. Your help would be much appreciated.

 

[yowanvista]

BSOD caused by AppleCharger.sys, It is a driver used so the motherboard can charge Apple hardware such as iPhones or iPods.
Remove it or update it

BugCheck 1E, {ffffffffc0000005, fffff80002f70f9a, 0, 4f}

Unable to load image \SystemRoot\system32\DRIVERS\AppleCharger.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for AppleCharger.sys
*** ERROR: Module load completed but symbols could not be loaded for AppleCharger.sys
Probably caused by : AppleCharger.sys ( AppleCharger+270c )

 

[wolfone]

Thank you for your prompt reply yowanvista. Last night I tried a reinstall of the Windows 7 64 bit operating system and rebooted each time I installed another driver (including motherboard drivers). The blue screen only reappeared during shutdown after installing the driver for my dual TV tuner card (Leadtek PCI Winfast DTV2000 DS). Would it be possible that the AppleCharger.sys is conflicting with the Leadtek driver in some manner OR is their a known problem with my TV tuner card? Thanks again.

 

[yowanvista]

AppleCharger.sys was the cause, you should uninstall this driver or the software using it
Or just go to C:\Windows\System32\drivers and rename AppleCharger.sys to AppleCharger.sys.old (do this in safe mode)

 

[wolfone]

Thanks again! Will do.

 

[trip127]

If you have a gigabyte board it is most likly there on/off charge utility. uninstall the on/off utility and it sould not do that anymore.

 

[NotAnAmbiTurner]

I know this is an old-ish post, but I am having the same issue.

Any luck/disaster finding a gigabyte-approved way to deal with this?

 

[NotAnAmbiTurner]

Found a solution:

To remove "applecharger.sys" (a.k.a. GIGABYTE ONOFF Charger) go to this page (GIGABYTE - Support & Downloads - Utility - Motherboard), D/L installer, run intaller, choose uninstall.

Now my comptr can install updates!!

 

[PaulVdB]

AppleCharger.sys was the cause, you should uninstall this driver or the software using it
Or just go to C:\Windows\System32\drivers and rename AppleCharger.sys to AppleCharger.sys.old (do this in safe mode)

This worked for me too !!!

Thanks yowanvista !

 

[PaulVdB]

Found a solution:

To remove "applecharger.sys" (a.k.a. GIGABYTE ONOFF Charger) go to this page (GIGABYTE - Support & Downloads - Utility - Motherboard), D/L installer, run intaller, choose uninstall.

Now my comptr can install updates!!

this didn't work for me. GIGABYTE has a new on/off app but even that didn't work.