BSOD - Boot From Sleep Mode

[ckamp]

Hello,

First, I must say this forum is a wonderful resource, thank you to the admins who make it happen.

As of today I have been getting a BSOD on 95% of my start-ups from sleep mode (close lid or press power button - as I setup)
I cannot figure this one out, please provide me with some insight.

As per forum standards I have included the information below along with the attachments.

Thank you in advance,


Is Windows 7 . . .- x86 (32-bit) or x64 ?
WINDOWS 7 HOME PREM OA 64Bit

- the original installed OS on the system?
YES, Re-installed on SSHD

- an OEM or full retail version?Purchased it from retailer- What is the age of system (hardware)
New, just purchased (MSI X460DX)

- What is the age of OS installation
New, 1 week.

 

[ckamp]

Any Ideas? I did a rollback to last week and the same BSOD occurs.

 

[ckamp]

Going to get home here after work and try a few things. Anyone have a look at this?

 

[writhziden]

The crashes point to the hard disk; likely causes are hard disk data corruption, hard disk errors, hard disk controller driver issues, and hard disk connection issues. The crashes may also be caused by viruses.

Also, since you have an SSD, make sure the following are up to date:

• SSD firmware
• BIOS version
• Chipset drivers
• Hard disk controller drivers

Check for data corruption and viruses.

• If you are overclocking any hardware, please stop.
  
  
• Run Disk Check with both boxes checked for all HDDs and with Automatically fix file system errors checked for all SSDs. Post back your logs for the checks after finding them using http://www.sevenforums.com/tutorials/96938-check-disk-chkdsk-read-event-viewer-log.html.
  For any drives that do not give the message:
  Windows has checked the file system and found no problems
  run disk check again as above. In other words, if it says:
  Windows has made corrections to the file system
  after running the disk check, run the disk check again.
  
  
• Run http://www.sevenforums.com/tutorials/1538-sfc-scannow-command-system-file-checker.html up to three times to fix all errors with a restart in between each. Post back if it continues to show errors after a fourth run or if the first run comes back with no integrity violations. Use OPTION THREE of http://www.sevenforums.com/tutorials/1538-sfc-scannow-command-system-file-checker.html to provide us with the sfcdetails.txt file if errors occur.
  
  
• Download and install Malwarebytes, update it, do not start the free trial, and then run a full scan. Also run a full scan with your antivirus software installed on your system. If you do not have antivirus software installed, see the http://www.sevenforums.com/system-s...-system-security-combination.html#post1732627 for better security steps and scanning tools. Make sure to update the security software before running the full scan.