BSOD help needed

[praga]

frequent BSOD Win 7 64

Hi
Im recently getting alot of BSOD
So can any one read this minidump files and explain the problem to me.
Im getting these BSOD mostly while on boot up
Thanxxx

 

[computersplus]

check the event viewer for event ID's flagged in red and post the event ID # please or post a screen shot

 

[praga]

check the event viewer for event ID's flagged in red and post the event ID # please or post a screen shot

I have uploaded the event viewer screenshot

 

[computersplus]

need a screen shot of lower half of screen if there are more errors flagged in red on the page

 

[praga]

need a screen shot of lower half of screen if there are more errors flagged in red on the page

there are so many in red this is for today's one

 

[stevieray]

I ran your 6 minidumps thru debugger, and I got 3 hardware BSOD, a memory corruption BSOD, a sys32 BSOD, and an unknown. I think you have a hardware problem.

Have you tried running memtest? If not, get it and run it overnight... let's see what it says. You also should get a HD diagnostic utility from your HD maker and run a test of the HD.

 

[computersplus]

was this a clean install or upgrade

that board has onboard video try removing the ATI card and see if errors stop I am leary of your power supply it's very generic and I'm sure is not providing enough amps on the +12 volt rail

 

[praga]

I ran your 6 minidumps thru debugger, and I got 3 hardware BSOD, a memory corruption BSOD, a sys32 BSOD, and an unknown. I think you have a hardware problem.

Have you tried running memtest? If not, get it and run it overnight... let's see what it says. You also should get a HD diagnostic utility from your HD maker and run a test of the HD.

yes i shud do that

was this a clean install or upgrade

clean install

you have a lot going on here

yee so many problems with my pc

that board has onboard video try removing the ATI card and see if errors stop I am leary of your power supply it's very generic and I'm sure is not providing enough amps on the +12 volt rail

PSU is not a generic its genuine 500W, so i guess its not the problem


I'm using and intel motherboard and i did BSEL mod for overclocking i guess the voltage is not enuf
but i did this mod long tym ago n now only im getting this problem.
so i did overclock to 3.2 for 2.4 and under-clocked to 3.0 now i guess now its stable

 

[computersplus]

there is more to a power supply than watts amps are even more important all the watts in the world are useless without enough amps behind it like I said try just onboard video and set things to stock speeds it's the only way your going to get to the bottom of your problems

 

[praga]

there is more to a power supply than watts amps are even more important all the watts in the world are useless without enough amps behind it like I said try just onboard video and set things to stock speeds it's the only way your going to get to the bottom of your problems

yee im gonna try that sooner
but i dont think there is a problem with my psu cz its fsp branded and 500W genuine and more than 30A @ 12v rails so thats more than enough for a 4850 and small overclocking
ill try to remove the bsel mod and try
Thanxx for the help