BSOD kernel_data_inpage_error 0x0000007a

[Ackix]

Mostly happens when i browse the internet.I've attached the file hopefully it's enought for you to find what's causing it.

 

[axe0]

Please go to %systemroot%\minidump in Windows Explorer and remove all files from 2014, after that run the tool again.
There are many files missing, probably due to the amount of dumps.

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

KERNEL_DATA_INPAGE_ERROR (7a)
The requested page of kernel data could not be read in.  Typically caused by
a bad block in the paging file or disk controller error. Also see
KERNEL_STACK_INPAGE_ERROR.
[COLOR="Red"]If the error status is [U]0xC000000E[/U], 0xC000009C, 0xC000009D or 0xC0000185,
it means the disk subsystem has experienced a failure.[/COLOR]
If the error status is 0xC000009A, then it means the request failed because
a filesystem failed to make forward progress.
Arguments:
Arg1: fffff6fc4002acd0, lock type that was held (value 1,2,3, or PTE address)
Arg2: ffffffff[COLOR="red"]c000000e[/COLOR], [COLOR="red"]error status (normally i/o status code)[/COLOR]
Arg3: 00000000498a3be0, current process (virtual address for lock type 3, or PTE)
Arg4: fffff8800559a000, virtual address that could not be in-paged (or PTE contents if arg1 is a PTE address)

Diagnostics Test

 HDD TEST

Run SeaTools to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use - Windows 7 Help Forums
Run following tests

1. Short Drive Self Test
2. Short generic
3. Long generic

If the short generic fails, no need for the long generic.

   Note

Do not run SeaTools on an SSD as the results will be invalid.

Run chkdsk
Disk Check - Windows 7 Help Forums

Run HDTune to

• scan for errors, no quick scan but full scan
• check the health,
• benchmark.

It may take some time, but please take the time you need to perform it properly.
Let me know what the results are

• of the error scan,
• make a screenshot of the health of every hard drive and post the screenshots,
• post screenshots with the benchmark of the
  • transfer rate,
  • access time,
  • burst rate,
  • cpu usage.