BSOD kernel_data_inpage_error after install new ssd

[airhsieh]

hi! I have a Asus ep121 tablet that ship out with 32GB ssd. so I upgraded it with midigitalssd MyDigitalSSD 128GB 50mm BP3 Bullet Proof 3 mSATA 6G SSD | My Digital Discount and after replaced the ssd, everything seems to be working fine untill I hit hibernation. When waking up the tablet, it will have BSOD kernel_data_inpage_error with Stop: 0x0000007a and restart itself. It will also happen when I plug in the power cord during useage.
I thought it was a bad drive and have it replace again, but the 2nd ssd is doing the same thing. What can I do? Please Help!

 

[writhziden]

SSD Troubleshooting:

For your SSD:

• Make sure the following are up to date:
  • SSD firmware
  • BIOS Version
  • Chipset Drivers
  • Hard disk controller drivers/SATA drivers
  • If you have a Marvell IDE ATA/ATAPI device, make sure the drivers are up to date from the Intel site or Marvell site and not from your motherboard/vendor support site.
  
  
• Try doing a power cycle of the SSD. The following steps should be carried out and take ~1 hour to complete.
  1. Power off the system.
  2. Remove all power supplies (ac adapter then battery for laptop, ac adapter for desktop)
  3. Hold down the power button for 30 seconds to close the circuit and drain all components of power.
  4. Reconnect all power supplies (battery then ac adapter for laptop, ac adapter for desktop)
  5. Turn on the system and enter the BIOS (see your manual for the steps to enter the BIOS)
  6. Let the computer remain in the BIOS for 20 minutes.
  7. Follow steps 1-3 and physically remove the SSD from the system by disconnecting the cables for a desktop or disconnecting the drive from the junction for a laptop.
  8. Leave the drive disconnected for 30 seconds to let all power drain from it.
  9. Replace the drive connection(s) and then do steps 4-8 again.
  10. Repeat steps 1-4.
  11. Start your computer normally and run Windows.
  
  The above steps were a result of: Why did my SSD "disappear" from my system? - Crucial Community
  
  While that may not be your drive, a power cycle should be the same on all SSD drives. See how the system responds after the SSD power cycle.

BSOD Instructions:

If you need further help after doing the above, please follow the http://www.sevenforums.com/crashes-debugging/96879-blue-screen-death-bsod-posting-instructions.html, and please fill in your system specs in your profile and not in a post in this thread: http://www.sevenforums.com/tutorials/180324-system-info-see-your-system-specs.html​