*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
Use !analyze -v to get detailed debugging information.
BugCheck D1, {68, 2, 1, fffff88002318a34}
Unable to load image \SystemRoot\system32\DRIVERS\USA19Hx64p.SYS, Win32 error 0n2
*** ERROR: Module load completed but symbols could not be loaded for USA19Hx64p.SYS
Probably caused by : USA19Hx64p.SYS ( USA19Hx64p+a34 )
Followup: MachineOwner
---------
0: kd> !analyze -v
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
DRIVER_IRQL_NOT_LESS_OR_EQUAL (d1)
An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high. This is usually
caused by drivers using improper addresses.
If kernel debugger is available get stack backtrace.
Arguments:
Arg1: 0000000000000068, memory referenced
Arg2: 0000000000000002, IRQL
Arg3: 0000000000000001, value 0 = read operation, 1 = write operation
Arg4: fffff88002318a34, address which referenced memory
Debugging Details:
------------------
WRITE_ADDRESS: GetPointerFromAddress: unable to read from fffff80002f07100
GetUlongFromAddress: unable to read from fffff80002f071c0
0000000000000068 Nonpaged pool
CURRENT_IRQL: 2
FAULTING_IP:
USA19Hx64p+a34
fffff880`02318a34 48874768 xchg rax,qword ptr [rdi+68h]
CUSTOMER_CRASH_COUNT: 1
DEFAULT_BUCKET_ID: WIN7_DRIVER_FAULT
BUGCHECK_STR: 0xD1
PROCESS_NAME: SRFeature.exe
TAG_NOT_DEFINED_c000000f: FFFFF80000BA2FB0
TRAP_FRAME: fffff80000ba2990 -- (.trap 0xfffff80000ba2990)
NOTE: The trap frame does not contain all registers.
Some register values may be zeroed or incorrect.
rax=0000000000000000 rbx=0000000000000000 rcx=fffffa8004eca010
rdx=fffffa8006e87780 rsi=0000000000000000 rdi=0000000000000000
rip=fffff88002318a34 rsp=fffff80000ba2b20 rbp=0000000000000002
r8=0000000000000001 r9=0000000000000000 r10=0000000000000000
r11=fffff8800231a8e0 r12=0000000000000000 r13=0000000000000000
r14=0000000000000000 r15=0000000000000000
iopl=0 nv up ei pl zr na po nc
USA19Hx64p+0xa34:
fffff880`02318a34 48874768 xchg rax,qword ptr [rdi+68h] ds:00000000`00000068=????????????????
Resetting default scope
LAST_CONTROL_TRANSFER: from fffff80002ccf1a9 to fffff80002ccfc00
STACK_TEXT:
fffff800`00ba2848 fffff800`02ccf1a9 : 00000000`0000000a 00000000`00000068 00000000`00000002 00000000`00000001 : nt!KeBugCheckEx
fffff800`00ba2850 fffff800`02ccde20 : fffffa80`04d623e0 fffffa80`046c2050 fffffa80`04b9b430 fffffa80`06292a10 : nt!KiBugCheckDispatch+0x69
fffff800`00ba2990 fffff880`02318a34 : 00000000`00000000 00000000`00000000 00000000`00000000 fffffa80`06292a10 : nt!KiPageFault+0x260
fffff800`00ba2b20 00000000`00000000 : 00000000`00000000 00000000`00000000 fffffa80`06292a10 fffffa80`05e116e0 : USA19Hx64p+0xa34
STACK_COMMAND: kb
FOLLOWUP_IP:
USA19Hx64p+a34
fffff880`02318a34 48874768 xchg rax,qword ptr [rdi+68h]
SYMBOL_STACK_INDEX: 3
SYMBOL_NAME: USA19Hx64p+a34
FOLLOWUP_NAME: MachineOwner
MODULE_NAME: USA19Hx64p
IMAGE_NAME: USA19Hx64p.SYS
DEBUG_FLR_IMAGE_TIMESTAMP: 471e6570
FAILURE_BUCKET_ID: X64_0xD1_USA19Hx64p+a34
BUCKET_ID: X64_0xD1_USA19Hx64p+a34
Followup: MachineOwner
---------
0: kd> lmvm USA19Hx64p
start end module name
fffff880`02318000 fffff880`02320c00 USA19Hx64p (no symbols)
Loaded symbol image file: USA19Hx64p.SYS
Image path: \SystemRoot\system32\DRIVERS\USA19Hx64p.SYS
Image name: USA19Hx64p.SYS
Timestamp: Wed Oct 24 02:49:44 2007 (471E6570)
CheckSum: 0001274E
ImageSize: 00008C00
Translations: 0000.04b0 0000.04e4 0409.04b0 0409.04e4