BSOD ntoskrnl.exe+7f1c0 CRITICAL_OBJECT_TERMINATION randomly

[Maroof83]

Hi All

I built a custom machine a month ago and been receiving very strange BSODs all with the same message for the last month.

All drivers are upto date including the SSD as primary and the BIOS

What happens is intermittent and my machine freezes for a few seconds then eventually starts BSOD and memory dumping.

I have done a full memtest, hdd check, gfx card stress test etc. All is good.

Theres even times I can be going for 12 hours straight without issues so Im not able to reproduce it unfortunately.

Attached are the diag tools outputs

Any help of course is greatly appreciated

Thx

Maroof

 

[JaidynM]

Hardware

I see you have an SSD installed. SSD drivers are a common cause of BSOD's, in particular Crucial M4's with outdated firmware. Make sure that the following is up to date:

• SSD Firmware
• BIOS Version
• Chipset Drivers
• Hard disk controller drivers/SATA drivers
• Marvell IDE ATA/ATAPI controllers (older drivers for these are especially problematic)

Software

Run a full system scan with Malwarebytes.
Malwarebytes : Free anti-malware download
​