How to stop being asked to choose between Start and Recovery

[KCav45]

How do I prevent Windows from asking me to choose between Starting Windows and running Recovery?,

 

[samuria]

If its asking that the disk has its dirty bit set you need to run chkdsk to check the drive

 

[KCav45]

If its asking that the disk has its dirty bit set you need to run chkdsk to check the drive

CHKDSK found no errors Also ran Memory Diagnostic and it found no errors.

 

[Megahertz07]

Open a CMD window and type
sfc /scannow

 

[KCav45]

Open a CMD window and type
sfc /scannow

Windows integrity scan did not find any violations.

How do I stop the system from asked me if I want to run Recovery each time I boot?

 

[KCav45]

Each time I boot a screen appears before I log in. I do not know why this screen appears. It refers to Memory Diagnostics, I have run Memory Diagnostics both Quick Check and Advanced, no errors found.
I would like to prevent the screen from appearing. What do I have to do to prevent it?

On the screen it says:

Choose an operating system to start, or chose Tab to start tools.
(Use the arrow keys to highlight your choice, then press ENTER)

Windows 7
Recovery

To specify an advanced option for this choice, press F8
Seconds until the highlighted choice will be started automatically n


Tools"
Windows Memory Diagnostics

 

[mrjimphelps]

It may be that if you boot to Safe Mode, you won't see that message. Then reboot into Normal Mode. Sometimes if Windows can successfully boot once, it will fix itself.

 

[Megahertz07]

Can you tell us what happens before this issue started?
Did you modify any MSconfig settings?

 

[KCav45]

It may be that if you boot to Safe Mode, you won't see that message. Then reboot into Normal Mode. Sometimes if Windows can successfully boot once, it will fix itself.

The screen appears when I boot in Safe Mode.

 

[KCav45]

Can you tell us what happens before this issue started?
Did you modify any MSconfig settings?

The only change I made was I started to use a portable printer that has a Direct Mode. I don't think this is the cause of the boot screen problem, but it is a recent change. The printer has a Direct Mode. When in DM I can wirelessly connect the printer to either my notebbook or cell phone. The printer
broadcasts a WiFi signal and I can go to Network and Settings and select it.

 

[KCav45]

Since the screen appears before I log in could it be a BIOS setting? I went there but could not identify which setting to change.

 

[Megahertz07]

There is nothing to do with BIOS settings.
Open MSConfig and check if:
- On General tab, startup is set to normal
- On Boot tab, no box is marked

 

[KCav45]

Could this error reported in Event Viewer have anything to do with the startup screen problem-

Event Viewer /Windows Log/System reports Event 34005,SharedAccess_NAT.
General - The ICS_IPV6 was unable to allocate 1 bytes of memory. This may indicate that the system is low on virtual memory or that the memory manager has encountered an internal errors.
Details -The event was not displayed correctly because the underlying XML is not well formed. Below is the raw text of the event.
34005030000x80000000000001333314SystemKCav-NB3

 

[KCav45]

There is nothing to do with BIOS settings.
Open MSConfig and check if:
- On General tab, startup is set to normal
- On Boot tab, no box is marked

Went to MSConfig, on the General tab, startup is set to normal; on the Boot tab, no box is marked, however on top of the Boot tab it says, "Windows 7 and Recovery, should that be there?

 

[KCav45]

Problem solved - after I reinstalled an image file of the System Partition that was made before the issue began.