ntoskrnl.exe + 1040b / e58d2 / 6d5be - DRIVER_POWER_STATE_FAILURE

[snahfu]

I have started getting blue screens, but only when I try and shut down my computer. The computer says its shutting down but takes abnormally long and then blue screens and restarts.

I have read a lot of things about ntoskrnl.exe related blue screens but nothing seems to fix my specific issue so I'm coming here for help. Any would be much appreciated.

Kind regards,
Felix

 

[Golden]

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck 9F, {3, fffffa8019016060, fffff80000b9c3d8, fffffa801b600010}

Unable to load image \SystemRoot\system32\DRIVERS\GEARAspiWDM.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for [COLOR="Red"]GEARAspiWDM.sys[/COLOR]
*** ERROR: Module load completed but symbols could not be loaded for GEARAspiWDM.sys
Probably caused by : atapi.sys

Followup: MachineOwner
---------

Driver Reference Table - GEARAspiWDM.sys

Update/replace CDROM driver using link above.

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck 9F, {3, fffffa8019b3a420, fffff800045003d8, fffffa801b3e0170}

Probably caused by : [COLOR="red"]HDAudBus.sys[/COLOR]

Followup: MachineOwner
---------

Driver Reference Table - HDAudBus.sys

Update audio bus driver using link above.

Run a general Windows update and install all device offered optional updates.

 

[snahfu]

Thanks so much for the reply! ill do both of those things. If i dont get another blue screen assume that fixed the problem.

Thanks again!

 

[snahfu]

Ok, I followed this guide to remove the drivers:
DRIVERS: Windows - Updating, removing, 64 bit versions, etc - GEAR Software Knowledgebase

But im still getting the blue screens every time I shut down. So i'll repost my SFdebug file, is it still the same driver causing the issue?