random BSOD errors

[style2k]

hi.

i am getting random bsod's lately. pc worked fine then 1 time i got a bsod and since that i keep getting them randomly.
i installed a fresh window version but i stil get those bsod's ..
i think it could have to do something with memory orso . but since im getting diferent error codes im not sure what it can be.
the errors apear mostly at or right after startup. and sometimes just when the pc is on for some time . i attached the file requested and hope that someone here knows where i should look for to fix this.

greets.

 

[koolkat77]

Welcome

STOP 0x00000050: PAGE_FAULT_IN_NONPAGED_AREA BSOD Index

Usual causes: Defective hardware (particularly memory - but not just RAM), Faulty system service, Antivirus, Device driver, NTFS corruption, BIOS

First run memtest86+ on each stick for 8 passes preferably overnight http://www.sevenforums.com/tutorials/105647-ram-test-memtest86.html

To make sure that hard drive is good run disk check following this tutorial :ar: http://www.sevenforums.com/tutorials/433-disk-check.html then Hard drive scan usings SeaTools :ar: SeaTools | Seagate both long and short tests.

Post back results

 

[style2k]

hmmm i try to run memtest . it boots fine . but it just keeps rebooting . scanning memory takes few seconds then it reboots . and this goes on forever ?
wierd

 

[Anthony]

System Specs Please!!

 

[centaur78]

hmmm i try to run memtest . it boots fine . but it just keeps rebooting . scanning memory takes few seconds then it reboots . and this goes on forever ?
wierd

What version of memtest are you using... Use the latest one and as advised by Koolkat77... one stick at a time for 6 to 8 passes

Update your system specs as adviced by Anthony ... if need help with that use this

All the BSOD are driver verifier enabled.... You can disable it for the time being.

 

[style2k]

updates system specs. also run ramtest for like 15 passes and no ram errors so it is not the ram that is faulty.
gonna check hardrive when im back

 

[style2k]

ok i did long generic test with seatools and boot hd failed passes short and fails smart check.. but the wierd thing is i installed the curent windows on a new hd .
so the old hd is now an extra data disk. and before i installed the curent windows i had the same bsod's (and that was the reason for a new instalation) with an other hd. and i checked that hd and that hd has passed all the tests ?? so whats left ? maybe bad sata ports ? is there a way to check those?

 

[Anthony]

When troubleshooting anything like this your best bet would be to remove all unnecessary Hardware.

Only one hard drive connected, One stick of ram in the first slot, One gfx card, remove any cards from the PCI Slots etc...

Then reinstall Windows, Once stable start adding back your hardware one at a time testing between each one.

Good Luck

 

[style2k]

i found an sata kable that was a little loose i pulled it out . when i restarted my pc the windows would not load anymore missing files orso .. but i had my other hd alsi connected with my previous windows and that worked now i did not get bsod since then but the computer just freezes it happned 2 times now and both times where within few minutes of startup.. i dont have a spare graphic card lyin now but is it possible that the gfx card make my pc crash?