Server 2003 TCP/IP problem

[The Coldest]

I keep getting
"Configure TCP/IP. The wizard has detected that there are no valid IP addresses assigned to any of the network adapters for this computer.
Please verifiy that the networks cable is connected, and that a DHCP server is available or the computer is configured to use a static IP address then click Next."

IP address 192.168.0.3
Subnet mask 255.255.255.0
Default gateway 192.168.0.1

any help would be appreciated, thank you

 

[SquonkSC]

I keep getting
"Configure TCP/IP. The wizard has detected that there are no valid IP addresses assigned to any of the network adapters for this computer.
Please verifiy that the networks cable is connected, and that a DHCP server is available or the computer is configured to use a static IP address then click Next."

IP address 192.168.0.3
Subnet mask 255.255.255.0
Default gateway 192.168.0.1

any help would be appreciated, thank you

Are those the IP's you set manually?

192.168.0.1 is the router?

What DNS IP have you set?

Greetz

 

[The Coldest]

yes they are static
192.168.0.1 is the router ip address
In the router DNS is set the get it from the ISP automatically

The server DNS is set as 192.168.0.1

 

[z3r010]

Does it work fine on dhcp?

 

[The Coldest]

This happen when I was installing active directory. There are no other server install on this network.

 

[SquonkSC]

This happen when I was installing active directory. There are no other server install on this network.

Can you ping the router?

 

[The Coldest]

no I can't ping the router. It is not even in the router lan group.

 

[SquonkSC]

no I can't ping the router. It is not even in the router lan group.

Does your networkcard say a cable is connected or not?

Check your cable.

Be sure you haven't used a crossed cable.

 

[The Coldest]

straight through cable, Nic is blinking in the back, the 2 little computer in the task bar says connect

 

[SquonkSC]

straight through cable, Nic is blinking in the back, the 2 little computer in the task bar says connect

Try setting DNS equal to the Gateway. 192.168.0.1

(don't forget the DNS it has now, in case you need to switch back)

Greetings

 

[The Coldest]

Figure it out the problem 1394 connection which is use for VPN. So I try look for the NIC driver on hp site. Come to find out they don't have drivers for server 2003 64bit. Solution: install a new NIC and disable on board NIC Thank for the help