G666Reaper
New member
- Local time
- 6:43 PM
- Messages
- 3
The system is a TX1000z (2.0GHz TL-60, 4GB RAM, Nvidia Go 6150, built-in wireless N/bluetooth,fingerprint scanner, quick-launch buttons) and after installing Windows 7 Ultimate x64 (clean install of course) I am getting the "found hardware" sound (no notification mind you). Then a few mins later, the same noise. Now there is no "disconnect" sound, and opening the device manager, and watching, it will refresh when the connection sound comes on, but I cannot see what device is causing this issue.
What do you guys think. If I knew what it was, obviously it would be much easer, but do you guys thing that maybe it's putting a piece of hardware to sleep? and then it comes back out of sleep? I would hate to go through every single device in the device manager and disable sleep mode to test this. I browsed through the event viewer, and nothing stood out. Open to suggestions... and thanks for the help....
:huh:
Charles
What do you guys think. If I knew what it was, obviously it would be much easer, but do you guys thing that maybe it's putting a piece of hardware to sleep? and then it comes back out of sleep? I would hate to go through every single device in the device manager and disable sleep mode to test this. I browsed through the event viewer, and nothing stood out. Open to suggestions... and thanks for the help....
:huh:
Charles
My Computer
- Computer Manufacturer/Model Number
- HP Pavilion TX1000z
- OS
- Windows 7 Ultimate x64
- CPU
- AMD 2.0GHz Dual Core TL-60
- Memory
- 4GB
- Graphics Card(s)
- Nvidia Go 6150
