Show Us Your Rig [2]

[YTBOY83]

I would Re-upload My New Layout, But i have Cans Littering the Place At the Moment

Does Anyone Have a Good Way of Lighting Up the Cases? I have a CM Elite 330 With 2 Led Blue Fans At the Moment But i want it to Really 'Glow'

Wish my desk was as Tidy as yours Beastie

You can buy usb lights which can be easily tidied away and Neon Cathodes which you can install on the case with a lil bit of modding. Neon Cathodes look great m8.

Hmm I might Get some Cathodes/diodes, But i Really dont want to end up Soldering my way to a Solution But if i have to I might Just Look at A Better Case :d

Thanks Tho

No problem m8, i am going to install some on top panel and around my left side panel, some case modding shall be required unless i can find a usb to molex cable.

Check this out m8

YouTube - ‪sound activated cold cathodes lights acrylic case pc‬‏

 

[YTBOY83]

In fact check all these out lol. YouTube - ‪pc cathodes‬‏ Very smart.

 

[Windows Sniper]

That Just Went Straight on My Wish List, I've Been looking for a Way to make a sound responsive light system do that For Ages, Now i need a Soundcard that i can do that with and some Cathodes

 

[YTBOY83]

That Just Went Straight on My Wish List, I've Been looking for a Way to make a sound responsive light system do that For Ages, Now i need a Soundcard that i can do that with and some Cathodes

That would be amazing for some gaming m8, my friend used to have smart green usb lights which he stuck to his desk which went with the audio m8. You could have your own party with that light system lol

 

[YTBOY83]

That Just Went Straight on My Wish List, I've Been looking for a Way to make a sound responsive light system do that For Ages, Now i need a Soundcard that i can do that with and some Cathodes

That would be amazing for some gaming m8, my friend used to have smart green usb lights which he stuck to his desk which went with the audio m8. You could have your own party with that light system lol

Like this, 3 Meter Blue EL Wire for Home Illumination - 6V with USB Connector: Amazon.co.uk: Lighting

 

[YTBOY83]

That Just Went Straight on My Wish List, I've Been looking for a Way to make a sound responsive light system do that For Ages, Now i need a Soundcard that i can do that with and some Cathodes

That would be amazing for some gaming m8, my friend used to have smart green usb lights which he stuck to his desk which went with the audio m8. You could have your own party with that light system lol

Like this, 3 Meter Blue EL Wire for Home Illumination - 6V with USB Connector: Amazon.co.uk: Lighting

Even, PK Green 2 Metre, 3.2mm Thick EL Wire With Battery Box, Neon Tube Glow Wire For Sign Lighting, Costume, Decoration, Festival, Car Illumination: Amazon.co.uk: Kitchen & Home Not as good as Cathodes, but could always be an extra.

 

[StalkeR]

Guys don't forgot this.
http://www.sevenforums.com/tutorials/159329-youtube-video-add-seven-forums-post.html

 

[Windows Sniper]

Guys don't forgot this.
http://www.sevenforums.com/tutorials/159329-youtube-video-add-seven-forums-post.html

Haha Cheers Stalker I knew That but with the amount of posts i think its a good idea just to link them

 

[Maxwell]

Cold Cathodes are great! I have some mounted on the back of my monitors for the ambient light that I have. I made a molex extension cord from an old power supply I had laying around, so they are still connected to my pc.

 

[YTBOY83]

Cold Cathodes are great! I have some mounted on the back of my monitors for the ambient light that I have. I made a molex extension cord from an old power supply I had laying around, so they are still connected to my pc.

Now that is smart mate, that is what i want to do, do they just stick on or how do they get installed m8?

 

[Windows Sniper]

I think he has Double Sticky Tape one the End Holders

 

[linnemeyerhere]

I think you can just see the foam tape between the to surfaces. That stuff is crazy strong and would be more than enough.

Well I've gone and done it, ordered a 128 gb Crucial 4m to replace the C300 Real 64 gb and then soon to top my Phenom OC'd processor off with the new Corsair H100 sans software/hardware upgrade which will be phase two if at all. Then if the system will support p/p fans I will run them as well, either way lots of pic's to follow when it arrives after current 2-3 week back order. The C300 will go into my laptop which should make it very happy then sandwich the WD 320gb 2.5 into the new enclosure and then I'll have 64gb C drive and 320 + 250 gb's externals via usb 2.0.

 

[YTBOY83]

Thanks

 

[Maxwell]

Now that is smart mate, that is what i want to do, do they just stick on or how do they get installed m8?

They stick on with double sided tape, then I took an old power supply and cut the molex cord out of it, and used that to create an extension cord for molex power. It was pretty simple to do but isn't exactly a straight forward process. I recommend if you have the money to get a the strips from Ikea.

DIODER Light strip - IKEA

Those things are sweet and you can change the colours whenever you want, which unfortunately I cannot do.

 

[NeroDevil]

Some more pic's of my lil beast. Nothing too OTT, but I love "her"

Worked a little more on the cable management - should be a little better now at least:

Before...

...After!

Comments greatly apprieciated!

 

[xarden]

I once had a Peavy amp too...

 

[LiquidSnak]

Looks good I'd like to see a blue lit top fan, but that's just me. Cable management looks great, any idea of your before/after temps?

 

[Windows Sniper]

What does cable management Really help in with computer temps ?

 

[LiquidSnak]

having something like an IDE cable can impede your airflow quite a bit, as well as cables everywhere. The air has to go in and come out to cool effectively, and follow pathways that will cover components. Not only does cable management look snazzy, it does help with temps.

 

[Beastie]

this is my old computer

still have it up and running doing other things
i took the heatsink and 2 video cards and put them in my current build

the old computer is a q6600 with 8 gigs ram it served it's purpose and was good for gaming