NTLDR Error Messege

[KCINREBAK]

Trying to install secondary drive in my desktop. got it all hooked up started my comp went into my BIOS but when I go into the boot priority menu it wont let me switch my primary drive to load as the first drive, it is booting from the slave. If I disconnect the slave and restart everything is fine so there is no problem with my MBR. Any hints why it wont let me switch the boot priority?

 

[theog]

Trying to install secondary drive in my desktop. got it all hooked up started my comp went into my BIOS but when I go into the boot priority menu it wont let me switch my primary drive to load as the first drive, it is booting from the slave. If I disconnect the slave and restart everything is fine so there is no problem with my MBR. Any hints why it wont let me switch the boot priority?

Make sure primary drive is pluged in to Sata 1.

 

[Zidane24]

Are your jumpers correct on the drives?

 

[KCINREBAK]

Yeah Jumpers are all good, everything is recognized in the bios it just wont let be switch boot priority. Am I just stupid or is there something very simple that I am missing

 

[Zidane24]

Is this the first time that you have hooked up both drives together? Have you updated your bios to the most current

 

[theog]

Yeah Jumpers are all good, everything is recognized in the bios it just wont let be switch boot priority. Am I just stupid or is there something very simple that I am missing

Try changing the plugs round on your IDE cable.

 

[Zidane24]

Actually I don't think anyone has even asked if his drives are SATA or IDE


so...which one are they?

 

[theog]

Actually I don't think anyone has even asked if his drives are SATA or IDE


so...which one are they?

Good point.

KCINREBAK specs are for a laptop.

 

[Mark Phelps]

Yeah Jumpers are all good, everything is recognized in the bios it just wont let be switch boot priority. Am I just stupid or is there something very simple that I am missing

OK, this happened to me, too. When I went to change boot sequence, even though I have three hard drives, it would not let me select any other drive.

Then ... I noticed another screen in the BOOT section that showed ALL the drives, and only the one at the TOP of the list was also seen in the boot sequence screen.

So, I moved the drive I wanted to the top of the drive list, and when I opened the boot sequence page again, that drive was shown.

This might be the same situation with your BIOS screens.