BCM20702A0 driver

[PatrickRobinson]

When trying to use the link you provided, the wizard starts then immediatley says it was "interrupted" before the software could install.

 

[maxie]

Install the Chipset Driver from the Link below ...


Product Support | Dell US

 

[PatrickRobinson]

Still....after installing chipset, up "Setup" still getting "no drivers have been loaded for this device", despite having successfully (supposedly) completed the WIDCOMM installation.

 

[PatrickRobinson]

hang on....just now unzipping the Chipset folder (my bad).

 

[PatrickRobinson]

Files say for Logitech

 

[maxie]

Files say for Logitech

Really ?

 

[PatrickRobinson]

Files say for Logitech

Really ?

Despite actually hearing the typical 2 tone audible recognition for a USB deivce being plugged in in the midst of running the to OEM Multi installs.......nothing.

 

[maxie]

Did you manage to get the Chipset Driver to Install ? ...

 

[PatrickRobinson]

Nothing has worked so far.
Uhhhhhhhhhg! It worked prior to my restoring from the factory image and then reinstalling the PRO 7 OS.

 

[maxie]

Run the Scan below and Post back the Result ...


http://www.sevenforums.com/tutorials/1538-sfc-scannow-command-system-file-checker.html

 

[PatrickRobinson]

Further, I just realized that an SD card I had previously used as ReadyBoost now says it does not have the required performance necessary. Good Lord!!!!! Its 8GB formatted NTFS and empty.

 

[maxie]

You are not having much luck ...

 

[PatrickRobinson]

Run the Scan below and Post back the Result ...


http://www.sevenforums.com/tutorials/1538-sfc-scannow-command-system-file-checker.html

OK....I have typed that in the command line and although there is no window showing the process, the HDD is obvioulsy working overtime...OK?

 

[maxie]

Yes hopefully it should run ...

 

[PatrickRobinson]

Where would I see "the Results"?
I typed in the command line: sfc /scannow

 

[maxie]

It should be doing the Scan now the Result should appear in the CMD Window ...

 

[PatrickRobinson]

It should be doing the Scan now the Result should appear in the CMD Window ...

There is no window....I see a brief flicker of the CMD window but it disappears in a millisecond

 

[maxie]

Oh dear not so good .. How long is it since you Re-Installed Windows ? ...

 

[PatrickRobinson]

this is killing me
CMD says You must be an administrator to use sfc utility

 

[Slartybart]

Well, I went to the site provided, installed etc.....nothing.
I had the device working fine 2 days ago. This is a Dell Inspiron 1012 which came with 7 starter which I upgraded to professional years ago. Today I chose to restored rom factory image to clean things up, and then I reinstalled 7 Pro....now all this. It doesn't make sense. What next?

19 hours ago, you Restored to factory - correct?

Was this from a partition or from Recovery discs?

The issues seem to begin after reinstalling Pro - yes?

See what MS thinks about the Pro version:
http://www.sevenforums.com/windows-...ne-activation-issue-posting-instructions.html

If there is an issue with the upgrade, that report will tell me something.