BSOD after wakeup ntoskrnl.exe (nt+0x76E80)

[portuer]

Hello!

I allready installed the newest drivers and firmware updates. Then I tried using "WhoCrashed" and "BluescreenView" but I could not find out who caused the BSD. :-( Any help would be wonderful. I uploaded the complete ZIP.

Thank you very much!!

 

[Golden]

Did you miss the information at the top of the page telling you exactly what information to post here to get BSOD help?

 

[portuer]

Sorry, I just changed the file to the correct one.

 

[Golden]

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck 4E, {99, 4200, 7, 0}

Probably caused by : memory_corruption ( nt!MiBadShareCount+4c )

Followup: MachineOwner
---------

Run a minimum of 8 consecutive passes, preferably overnight, or until errors occur using MemTest86+.

Reference:
http://www.sevenforums.com/tutorials/105647-ram-test-memtest86.html

 

[portuer]

Thank you Golden!

Memtest86+ 5.01 runs now for about 9,5 hours and had 4 passes and 0 errors. How long should I still let it running?

Thank you and kind regards,
Portuer

 

[Golden]

Run a minimum of 8 consecutive passes, preferably overnight, or until errors occur

See above

 

[portuer]

Well, ok. So it will take 18h in total. I will let it run.
Thank you to Australia (was there for 2 months 1 year ago)

 

[portuer]

9 passes, no errors. What now?

It happes occasionally and usually when I wake up the pc from standby.

 

[Golden]

Please do the following:

Run Driver Verifier for 24 hours or the occurrence of the next crash, whichever is earlier.
http://www.sevenforums.com/tutorials/101379-driver-verifier-enable-disable.html

Driver Verifier will cause your computer to run very sluggishly - this is normal. What it is trying to do is force your system to BSOD and isolate the offending driver/s. When it does, reboot, disable driver verifier, reboot as normal and upload the new dmp file/s here.

I recommend creating a system restore point before turning on driver verifier:
http://www.sevenforums.com/tutorials/697-system-restore-point-create.html

If your system fails to boot to desktop once driver verifier is enabled, turn it off by booting into Safe Mode:
http://www.sevenforums.com/tutorials/69585-safe-mode.html