DVD Burn Process Failure

[JerometheGiraff]

I have a problem with my DVD drive. When a DVD begins to burn I get an error, "Burn Process Failed". There is no firmware upgrade for my DVD player, what is the cause.

 

[1Bowtie]

You've been here for almost 400 post and no system spec's, it's a little hard to diagnose a problem without them, need to know the make and model of the dvd drive maybe the laser went bad.

 

[JerometheGiraff]

Rule out some possibilities, or options.

 

[MilesAhead]

You've been here for almost 400 post and no system spec's, it's a little hard to diagnose a problem without them, need to know the make and model of the dvd drive maybe the laser went bad.

I have to assume either A) the OP is really stubborn or B) he's doing support and reflecting problems into this forum for the solutions.

 

[A Guy]

No system specs, no help

http://www.sevenforums.com/tutorials/180324-system-info-see-your-system-specs.html

A Guy

 

[JerometheGiraff]

I did a firmware update, the problem continues, the DVD can play DVD's but can't write ?

TEAC DV-WS8S-RT 7.0D (Previously 7.0C)
Preparting compilation
Burn Process Started
Closing Track
*Burn process failed (A write error occurred)*

​

 

[F5ing]

Inferior quality media? Too fast of a write speed?

 

[ibshaw]

Depending on what software you use to decode and burn the DVD can cause this problem i.e I use ConvertXtoDVD and if you go straight to burn from decoding a .avi file it will give the exact error you have. I still use this software but instead I stop after the decode close the program then open it again and select "burn a project already converted" and the burn works fine after that - a bit of a pain but works for me.

 

[JerometheGiraff]

Took :40 min, it just worked, odd !

 

[A Guy]

Took :40 min, it just worked, odd !

Well...It's a computer...

A Guy