Solved I cannot install Windows 7 64 bit on my new system?

[YUNOWork64Bit]

Thanks I will try this right now.

 

[YUNOWork64Bit]

I can't go to safemode before it boots up I don't know why. My Motherboards screen comes up and says press F2 to go to BIOS, F6 for flash screen, F11select boot device,TAB switch screen. I still mash the F8 key but advanced boot up options does not come up on screen.

 

[YUNOWork64Bit]

OK I just got advanced boot options and safe mode. But. When it tries to load it gets the same error screen as it usually does.

The error says: "A problem has been detected and Windows has been shut down to prevent damage to your computer.

If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow these steps.

Check to be sure you have adequate disk space. If a driver is identified in the Stop message, disable the driver or check with the manufacturer for the driver updates. Try Changing video adapters.

Check With your hardware vendor for any BIOS updates. Disable BIOS memory options such as caching or shadowing. If you need to use safe mode to remove or disable, restart your computer press F8 to select Advanced startup options and then select safe mode.

Technical information:
***STOP: 0x0000007E (0xFFFFFFFFC0000005, 0XFFFFF88003172F97, 0XFFFFF880039AF558, 0XFFFFF880039AEDB0)

*** mrxsmb10.sys - Address FFFFF88003172F97 base at FFFFF88003147000, DateStamp 4a5bc218

 

[gregrocker]

Post up the crash file in our Crashes forum for expert analysis: Blue Screen of Death (BSOD) Posting Instructions - Windows 7 Forums

While you wait test your RAM - Test with Memtest86+ for 5-6 passses

Did you wipe the HD as suggested?

Test your HD with maker's HD Diagnostic extended CD scan.