Random BSOD memory_corruption .zip attached

[Cami1]

Hi!
BSOD mostly appears while playing minecraft counter strike and watching videos,stream,movies etc. I tryed fresh instaling windows twice and windows repair tool and it did not found any disc errors or anything. Windows debugger says memory_corruption, few times it was irql_not_less_or_equal and even ntoskrnl.exe but i dont know what that means or how to repair it. Please help me. Thank you

 

[HarriePateman]

The BSOD reports a memory corruption.

BugCheck 109, {a3a039d89965d590, b3b7465eebe2a4e6, fffff80002eccc60, 1}

[COLOR=Red]Probably caused by : memory_corruption[/COLOR]

Followup: memory_corruption
---------

Test your RAM modules for possible errors.

How to Test and Diagnose RAM Issues with Memtest86+​

If there is no error, enable Driver Verifier to monitor the drivers.

Driver Verifier - Enable and Disable
​

   Warning

Before enabling DV, make it sure that you have earlier System restore points made in your computer. You can check it easily by using CCleaner looking at Tools > System Restore.

If there is no points, make a System Restore Point manually before enabling DV.

   Tip

• If you fail to get on the Desktop because of DV, Boot into Advanced Boot Options > Safe mode. Disable DV there. Now boot normally again, and try following the instruction of enabling DV again.
• If you cannot boot in Safe mode too, do a System Restore to a point you made earlier.

 

[Cami1]

Hi again.
i ran memtest whole night it did 5 passes and no errors at all. With driver verifier i get BSOD after welcome message and it says attempt to write to read-only memory. I attatched new minidump files.

 

[HarriePateman]

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck BE, {fffff80002fc43d0, 8000000002fc4121, fffff8800331da30, a}

*** WARNING: Unable to verify timestamp for [COLOR="red"]MBfilt64.sys[/COLOR]
*** ERROR: Module load completed but symbols could not be loaded for [COLOR="Red"]MBfilt64.sys[/COLOR]
Probably caused by : MBfilt64.sys ( MBfilt64+1817 )

Followup: MachineOwner
---------

It was a driver that failed this time: Realtek HiDefinition Audio driver (file labelled as Creative Audio Driver), update this and that should solve that problem.

Inregards to your RAM, please can you run it for 9 passes just to make sure.