Re-occuring BSOD

[Jesture]

Keep getting random BSOD stop errors,

STOP: 0x00000050, 0x0000000A, 0x0000001E, 0x000000D1, 0x0000003B, 0x00000018


Attached is a ZIP using the SF Diagnostic Tool.

Some assistance would be greatly appreciated.

Thanks,
Matt

 

[Arc]

Hi Jesture.

Your system specs says:

Memory 16 GB, 4 x 4GB 1333

But your system says ....

Installed Physical Memory (RAM)    6.00 GB

It is 3x2 GB Micron RAM. Have you changed the RAM? Was there any adequate reason?

The versatility of the bugcheck codes and probable causes are giving a notion to RAM problem.

Test your RAM modules for possible errors.
How to Test and Diagnose RAM Issues with Memtest86+
Run memtest for at least 8 passes, preferably overnight.

If it start showing errors/red lines, stop testing. A single error is enough to determine that something is going bad there.

Is the computer hot? Report us the heat of the computer after a couple of hours of your normal usage. Upload a screenshot of the summery tab of Speccy. Alternatively, you can publish a Speccy snapshot too: http://www.sevenforums.com/tutorials/311593-speccy-publish-snapshot-your-system-specs.html .

Check if the Power Supply Unit (PSU) supplying adequate power to the computer or not.
eXtreme Power Supply Calculator
Also let us know the wattage of the PSU.

Search for any possible BIOS update with HP. the installed one is old.

BiosVersion = 6.09
BiosReleaseDate = 09/07/2010

Let us know the results.

 

[Jesture]

Good Day,

Thank-you for your reply.

I previously had 4 x 4GB 1333 memory installed.
With the BSOD I was getting I wanted to swap out this memory for the memory that came with the PC. which was 3 x 2GB 1333. This was a mistake as it ended up causing more errors...ended up putting back in my 4 x 4GB 1333 memory.

I was having heating issues afew months ago...my processor would reach its Tj. max then I would get BSOD. I ended up installing a Thermaltake Water 2.0 Performer and the BSOD stop...this lasted almost 2 months...then the BSOD started to re-occur.

Memory.
Whenever I run the memtest everything comes up clear. It does take awhile, but I still think there are issues with my memory. My PC came preloaded with Hardware Diagnostic Tools, Powered by PC Doctor. Whenever this runs, 9 times out of 10 it would get caught up on the memory tests and I would have to cancel the test. But, when I run memtest...everything comes up all clear..so it beco

My PSU is a rocketfish500w.
I never had issues with my PSU before, however, there is quite afew items plugged in the powerbar...could the PSU be Choking...not getting enough power...note...not all of the items in the powerbar are on at the same time.

I entered the data regarding my PSU on eXtreme Power Supply Calculator. Based on the data entered I require a PSU of 448w (Recommended).

 

[Arc]

How many passes you ran the memtest86+?

 

[Jesture]

I ran the memtest86+ for almost 14 hours. Had 4 passes zero errors.
Pic attached.

 

[Arc]

It is suggested that you run memtest86+ for at least 8 passes, in order to be substantially sure that the memory is OK.