Very slow after waking up from sleep mode

Dan33185

New member
Member
Local time
7:53 PM
Messages
56
I'm having a weird problem that just started in the past week or so. On my laptop, I have it set to go into sleep mode when I close the lid. Within the last week or two, when I open it back up, it's ridiculously slow to start running again. I usually get a black screen for 10-15 seconds, and I can see and move the cursor. After that, I usually get the bluish green welcome screen that stays for another 10-15 seconds. My desktop finally pops up after that, but even then everything runs ridiculously slow, to the point it's faster just to unplug the cord and pop out the battery and restart everything. I've run diagnostics, system check, etc., anything I can think of, and still no fix. Anyone else experience this and have any suggestions?
 

My Computer My Computer

At a glance

MS Windows 7 Home Premium SP 1 64-bitIntel (R) Celeron (R) CPU 900@ 2.20 GHz2 GB
Computer Manufacturer/Model Number
Compaq Presario CQ60 Notebook PC
OS
MS Windows 7 Home Premium SP 1 64-bit
CPU
Intel (R) Celeron (R) CPU 900@ 2.20 GHz
Memory
2 GB
Hard Drives
Seagate ST9250410AS ATA 220 GB
Other Info
HP DVDRAM GT30L ATA

Synaptics Ps/2 port touchpad

Atheros AR9285 802.11b/g/n WiFi Adapter

Conexant Pebble High Definition Smart Audio

Total Recorder WDM Audio Driver

Generic PNP Monitor
Try shutting the computer completely down (without either hibernating or sleeping), and then starting it back up again.

If the computer sleeps or hibernates, whatever issue there might be will continue to be alive when you wake the computer up. however, if you shut the computer all the way down then restart it, you might end up killing whatever is causing this problem.

If that doesn't fix it, then there may be a service running in the background which is causing the delays and slowness. To test that, you can run MSCONFIG, go to the Services tab, hide all Microsoft services, then disable all services which are showing on the screen (that is, the non-Microsoft services). Then reboot.

If that fixed it, then there is a service which is slowing things down. To find out which one it was, go back into MSCONFIG and re-enable one service at a time, rebooting after each re-enable. Then use the computer a bit, to test it. When things slow down, you will know which service was the culprit. Go back into MSCONFIG and disable that service.

Continue re-enabling services one at a time, to see if there are any more culprits. In this way, you will disable only the culprits, not any needed services.
 

My Computer My Computer

At a glance

Linux Mint 18.2 xfce 64-bit (VMWare host) / W...Haswell4 GB
Computer type
PC/Desktop
Computer Manufacturer/Model Number
Dell
OS
Linux Mint 18.2 xfce 64-bit (VMWare host) / Windows 8.1 Pro 32-bit (VMWare guest)
CPU
Haswell
Memory
4 GB
Monitor(s) Displays
Acer 23"
Screen Resolution
1920 x 1080
Hard Drives
Two hard drives, 1TB each: One for Linux, one for my data.
Keyboard
IBM Model M
Antivirus
Sophos (Linux), Trend Micro (Windows)
Browser
Firefox, Opera
Other Info
I use Samba to share my data drive with the other computers at my house and with my guest session in VMWare Workstation Player.
Thanks for the response. To the first part, I have shutdown and restarted quite a few times over the past week or two, and the problem persists unfortunately. To your second suggestion, I looked into MSCONFIG and there were a few things checked that I unchecked and then restarted. I will let the computer sleep for a bit and see what happens at that point and report back. Also, quick question, is one better than the other: sleep or hibernate?
 

My Computer My Computer

At a glance

MS Windows 7 Home Premium SP 1 64-bitIntel (R) Celeron (R) CPU 900@ 2.20 GHz2 GB
Computer Manufacturer/Model Number
Compaq Presario CQ60 Notebook PC
OS
MS Windows 7 Home Premium SP 1 64-bit
CPU
Intel (R) Celeron (R) CPU 900@ 2.20 GHz
Memory
2 GB
Hard Drives
Seagate ST9250410AS ATA 220 GB
Other Info
HP DVDRAM GT30L ATA

Synaptics Ps/2 port touchpad

Atheros AR9285 802.11b/g/n WiFi Adapter

Conexant Pebble High Definition Smart Audio

Total Recorder WDM Audio Driver

Generic PNP Monitor
Both Sleep and Hibernate take a snapshot of your Windows session, then "shut down" the computer. Hibernate writes the snapshot to your hard drive, so it is able to fully power down the computer; however, because hibernate keeps the snapshot on the hard drive, it takes a bit longer to resume where you were than resuming from sleep. Sleep keeps the snapshot in memory, and keeps a little bit of power running, enough to maintain the image in memory. Since the snapshot is in memory, it resumes faster than hibernate. Hybrid sleep puts the snapshot both in memory and on the hard drive, so that if there is a loss of power, it can get the image from the hard drive; whereas if there is no loss of power, it can restore faster (from memory).

You need to be able to completely shut Windows down at times, rather than simply powering down then resuming what you were doing. Therefore, I recommend to people that they set their power options so that holding the power button in does an actual Windows shutdown rather than a sleep or a hibernate.
 

My Computer My Computer

At a glance

Linux Mint 18.2 xfce 64-bit (VMWare host) / W...Haswell4 GB
Computer type
PC/Desktop
Computer Manufacturer/Model Number
Dell
OS
Linux Mint 18.2 xfce 64-bit (VMWare host) / Windows 8.1 Pro 32-bit (VMWare guest)
CPU
Haswell
Memory
4 GB
Monitor(s) Displays
Acer 23"
Screen Resolution
1920 x 1080
Hard Drives
Two hard drives, 1TB each: One for Linux, one for my data.
Keyboard
IBM Model M
Antivirus
Sophos (Linux), Trend Micro (Windows)
Browser
Firefox, Opera
Other Info
I use Samba to share my data drive with the other computers at my house and with my guest session in VMWare Workstation Player.
If that doesn't fix it, then there may be a service running in the background which is causing the delays and slowness. To test that, you can run MSCONFIG, go to the Services tab, hide all Microsoft services, then disable all services which are showing on the screen (that is, the non-Microsoft services). Then reboot.

If that fixed it, then there is a service which is slowing things down. To find out which one it was, go back into MSCONFIG and re-enable one service at a time, rebooting after each re-enable. Then use the computer a bit, to test it. When things slow down, you will know which service was the culprit. Go back into MSCONFIG and disable that service.

So unfortunately that didn't work, I opened it tonight and went through the same problem, just a black screen with the cursor on it for a few minutes. Any other ideas I could try? I'm willing to try anything at this point (short of reformatting completely).
 

My Computer My Computer

At a glance

MS Windows 7 Home Premium SP 1 64-bitIntel (R) Celeron (R) CPU 900@ 2.20 GHz2 GB
Computer Manufacturer/Model Number
Compaq Presario CQ60 Notebook PC
OS
MS Windows 7 Home Premium SP 1 64-bit
CPU
Intel (R) Celeron (R) CPU 900@ 2.20 GHz
Memory
2 GB
Hard Drives
Seagate ST9250410AS ATA 220 GB
Other Info
HP DVDRAM GT30L ATA

Synaptics Ps/2 port touchpad

Atheros AR9285 802.11b/g/n WiFi Adapter

Conexant Pebble High Definition Smart Audio

Total Recorder WDM Audio Driver

Generic PNP Monitor
Back
Top