Win7 Stuck/Restart/kernel-power 41

[arielbgb]

Hello, first of all I will note that I'm currently in SAFE MODE with NETWORK Because my cp is not holding me over a few minutes until It stuck or reboot, without blue screens even though I took the check to restart automataic when an error apply ...
My spec:Win7, ACER ASPIRE X1700
ATI card READON HD3500/4000

After I dug in various forums in the world with similar problems could not fix it. I've had problems with blue in the last year screens ,What I did was I unpacked the computer, I replaced the glue / paste special under the fan and put him back somehow only this helped and the computer was good without reboots until recently.

In the Events diary its shows critical errors KERNEL-POWER 41 after searching in the net I try some solutions:
Updates of Windows update + Drivers
I checked memories, cleaned dust, heat checking and some solutions that I do not remember, anyway nothing work and i'm hopeless .... I checked with the BLUESCREENVIEW Tool DUMP files and there is nothing from the past year. I working on the SAFE MODE NETWORKING almost an our and its works fine ... but of course it's not a solution ...
I join the files from thr instrucations but please notice that the dump files old.
... If you need me to upload something or tell more more please ask, thanks :]


little update

after been in safe mode with network almost 2 hours its reboot ...

 

[arielbgb]

guys..?

 

[arielbgb]

??any1?

 

[writhziden]

The fact that you are getting crashes in safe mode indicates hardware as the most likely cause.

To rule out BIOS corruption, you may also want to clear the CMOS. How To Clear CMOS (Reset BIOS)

Strip down your system to run only the bare essentials: one RAM module, the CPU, motherboard, hard disk, graphics card (or use onboard graphics if you have it), keyboard, mouse, and monitor. See how the system behaves by running Windows for twice as long as it typically takes for you to get a crash. If it is stable, add one piece of hardware back at a time until you get crashes again. Take notes of what hardware you add and how the system responds to the hardware changes.

As you add and remove hardware, follow these steps for ESD safety:

1. Shut down and turn off your computer.
2. Unplug all power supplies to the computer (AC Power then battery for laptops, AC power for desktops)
3. Hold down the power button for 30 seconds to close the circuit and ensure all power drains from components.
4. Make sure you are grounded by using proper grounding techniques, i.e. work on an anti-static workbench, anti-static desk, or an anti-static pad. Hold something metallic while touching it to the anti-static surface, or use an anti-static wristband to attach to the anti-static material while working.

Once these steps have been followed, it is safe to remove and replace components within your computer.

 

[arielbgb]

Hi thanks 4 the help...
I take some steps forward and fixed it...
the problem was the capacitor in the motherboard 2 of them blown up and I replace them...
now I'm 1 hour use and its looks fine :]
TY!

 

[writhziden]

Glad you tracked it down. Nice work. You must have an electrical background; we don't usually recommend replacing electrical components for the average user, but I am happy your system is up and running again.

 

[arielbgb]

yhea I took it to labe of electronic they take 40 shekels (israeli money) its like 10$ and now its work fine...ty :]