Computer crashed - BC Code 124

[Rawkt]

As in windows will not start without getting a blue screen.
If that happens you can revert to the restore point you created earlier.

Alright, thanks!

 

[Rawkt]

Did you run Prime95 again for around 2 hours?
If not please run it, if so and no errors came up then I recommend running Driver Verifier by following these instructions

http://www.sevenforums.com/tutorials/101379-driver-verifier-enable-disable.html

So right now I'm running the Driver Verifier and Windows has found that both crashes that occurred was due to a 'Video Hardware Error', BC Code 117.

I'll upload the new dump files now!

EDIT: Okay, even though it says there is a dump file called 'WD-20140223-1821.dmp', I can't seem to find it in the folders where the dump files should be... I'll upload what it shows when I click on View Technical Details.

View attachment 315781

View attachment 315782

 

[Thedoctor44]

I can't see any reply regarding the results of Furmark.

Please run it for around 30 minutes.
Follow these instructions.

http://www.sevenforums.com/tutorials/100356-video-card-stress-test-furmark.html

 

[Rawkt]

I can't see any reply regarding the results of Furmark.

Please run it for around 30 minutes.
Follow these instructions.

http://www.sevenforums.com/tutorials/100356-video-card-stress-test-furmark.html

Alright, will do.
So far no BSODs with verifier running.

 

[Rawkt]

I ran Furmark for the half an hour, it took about 5-6 minutes for the temperatures to reach 80 degrees where it began to stabilise and didn't fluctuate much from the 80-83 range. No artifacts appeared and the temperatures didn't keep rising.

As for the Driver Verifier, I have turned it off, no BSODs appeared when I was running it.