New
#1
To slipstream my upcoming Repair Install (or not to slipstream . . .)
Hi,
I have experienced the SP1 install failure because not only had I been using Driver Sweeper, and Driver Cleaner.net before that. Even worse, I have switched between NVidia and ATI graphics cards two or three times, back and forth. Currently have an Nvidia card, so no ATI needed, other than chipset, etc. (AMD). I have known for a while that I had a bunch of ATI drivers I didn't need, cuz SFC always shrieked about certain of the ati & nv drivers/manifests.
Anyway, I have been getting ready to do a repair install, hoping that'll do the trick and lay down the files properly, but now since SP1 is out, is there any reason I should wait to install it after the upgrade, rather than what I'd like to do, i.e. run a slipstreamed version.
Anyway, any advice, welcomed.
PS: I don't worry about wanting to uninstall SP1 -- after having read the nonexistent RelNotes. (There are NO issues experienced apparently. That is so solid. Never happened when I was a tester at Redmond, so they must have set the bar quite high on admitting fixes, early in the release stage, and locked down the code. Good for them!