Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.

Windows 7: Windows 7 reinstall stalling at "Setup is starting" and other problems

11 Mar 2012   #1

Windows 7 Home Premium x64
Windows 7 reinstall stalling at "Setup is starting" and other problems

Hey everyone,

Yesterday my install of Windows started having issues. The system would periodically BSOD after the Windows startup logo appeared. I've tried every type of safe mode, last known good config, and startup repair, but to no avail. I had a Windows 7 install disk from my desktop (OEM) from when I built it and decided to try starting it from that. However, while I can get to the install page which has the install button as well as the repair option, when I click on either one, nothing happens.

When I click on the Repair button, it goes to a blank blue wallpaper (the standard win7 wallpaper) and sits there, doing nothing for about 5 minutes, before I just shut it off. Then I tried the standard install option, but it hangs on the "Setup is starting..." dialog and just sits with the loading cursor.

Other info:
I cannot get into the desktop, so anything that requires that will be no good.
I have tried Seatools to see if it's an HDD issue, but it would not open properly, even though I burned the .iso correctly.
Both installs are x64, so the disk should work.

Thanks for any ideas.

My System SpecsSystem Spec
11 Mar 2012   #2


You can try these steps for when Windows 7 fails to boot

Or you can skip to Clean Reinstall Windows 7 Factory OEM - same steps with your BUilder's OEM key.

If it continues to stall at boot, try another ISO from the tutorial just above, burned with tool given to DVD, or written to flash stick if that fails. This will tell us if it is the installer.

If not try resetting the BIOS to defaults: Clear CMOS - 3 Ways to Clear the CMOS - Reset BIOS

You may also need to wipe the HD with Diskpart Clean Command accessing DISKPART At PC Startup
My System SpecsSystem Spec

 Windows 7 reinstall stalling at "Setup is starting" and other problems

Thread Tools

Similar help and support threads
Thread Forum
Install windows stuck on "setup is starting", cmd won't use commands
After following the tutorials on the site to get windows on a flash drive or dvd, i used that to run the installer. sadly, after you hit "start to install" it goes into a seemingly infinite setup is starting cycle where ultimately nothing happens. any solutions would be appreciated also, i read...
Installation & Setup
windows 7 reinstall freezing at "Setup is starting services"
I ran Spybot Seek and Destroy on my Gateway laptop running Windows 7 64-bit Home Premium. My startup time had gone to a crawl as had the time to load pages in explorer. After Spybot was done it reccomended to "quarentine" certain files which I did and saved the registry of those files. When I...
Installation & Setup
Acer Aspire - Windows 7 reinstallation stuck on "Setup is starting"
Hi all, I am trying to reinstall Windows 7 on my notebook (Acer Aspire 5742-7645) from the DVD. I get as far as this screen: When I click "Install now," the screen says "Setup is starting..." and then never moves on. I have gone into BIOS...
Hardware & Devices
resuming Windows ... Setup is starting services..."stuck" Aspire5742
I was trying to save some files in restoring windows 7; now i can't boot my computer; 1st screen : windows resuming., then setup is starting services.... , "stuck" ; acer aspire 5742 Windows 7 64bit Home Premium; What can i do? now; F8;F2; F12; Ctr+Alt+Del; nothing runs all night ; have a recovery...
Installation & Setup
Unable to reinstall Windows 7 - "Setup is starting..." hang.
There are quite a few problems with my system right now. I'm unable to run windows normally thanks to the "BOOTMGR is missing" error. When I try to reinstall Windows 7, it hangs on the "Setup is starting..." screen. When I open the cmd.exe using SHIFT+F10, I am able to access all of my drives,...
Installation & Setup
Nvidia driver? is stalling boot at "Starting Windows" screen
Hi guys! I'm really in desperate need of more heads to work on this. I know this is a long post, but it's basically info you're gonna need anyways. Please i need the help - If you don't feel like reading, Just skim over the underlined titles.. I have been trying all sorts of things, since...
General Discussion

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 01:13.
Twitter Facebook Google+ Seven Forums iOS App Seven Forums Android App