BSOD occurs consistently within minutes of boot

[EpictheIII]

Hello!

So basically, the problem started this morning, every time i boot I am able to log in for about 15 seconds to half a minute before the included BSOD occurs. throughout the day I have done a system restore point. Prior to the system restore point, i was not able to boot in safe mode, however, i am now able to boot in safe mode which allowed me to conduct a few sfc /scannow which yielded corrupted files which couldn't be patched. i will upload the CBS if needed.

Thanks for any and all help, until i can get this worked out my main computer is completely un-usable.

 

[Arc]

Hello EpictheIII.

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

[COLOR=Red]BugCheck D6[/COLOR], {fffff98006be7018, 0, fffff88001440b15, 0}

*** WARNING: Unable to verify timestamp for vrtaucbl.sys
*** ERROR: Module load completed but symbols could not be loaded for vrtaucbl.sys

Could not read faulting driver name
[COLOR=Red]Probably caused by : portcls.sys [/COLOR]( portcls!GetMaxMapRegisters+5 )

Followup: MachineOwner
---------

According to Carrona.org, STOP 0x000000D6: DRIVER_PAGE_FAULT_BEYOND_END_OF_ALLOCATION
Usual causes: Device driver

Your crash dumps are not showing any finite probable cause. In such a situation, it is better to enable Driver Verifier to monitor the drivers.
Driver Verifier - Enable and Disable
Run Driver Verifier for 24 hours or the occurrence of the next crash, whichever is earlier.

   Information

Why Driver Verifier:
It puts a stress on the drivers, ans so it makes the unstable drivers crash. Hopefully the driver that crashes is recorded in the memory dump.

How Can we know that DV is enabled:
It will make the system bit of slow, laggy.

   Warning

Before enabling DV, make it sure that you have earlier System restore points made in your computer. You can check it easily by using CCleaner looking at Tools > System Restore.

If there is no points, make a System Restore Point manually before enabling DV.

   Tip

• If you fail to get on the Desktop because of DV, Boot into Advanced Boot Options > Safe mode. Disable DV there. Now boot normally again, and try following the instruction of enabling DV again.
• If you cannot boot in Safe mode too, do a System Restore to a point you made earlier.

Let us know the results, with the subsequent crash dumps, if any.

Also, Free up the startup.

1. Click on the Start button
2. Type “msconfig (without quotes), click the resulting link. It will open the System Configuration window.
3. Select the “Startup” tab.
4. Deselect all items other than the antivirus.
5. Apply > OK
6. Accept the restart.

Update the following drivers:

• Marvell MV91xx AHCI/RAID driver : Marvell - Support
• Atheros Bluetooth Driver: ATHEROS drivers for Microsoft Windows (Atheros?????)
• Intel Management Engine Interface: Intel Download Center
• JMicron RAID Driver: Driver
• nVidia Video drivers: from Drivers - Download NVIDIA Drivers
• Realtek High Definition Audio Function Driver:

Let us know the results.