Can't access router page in bridging mode.

[CommandoBob]

Hello,

I've set my router on bridging mode, and now i can't access my router page. My router is a ZyXEL P602HW-D1A. Any help please? Thanks.

 

[chev65]

This bridge mode set up page for your ZyXEL P602HW-D1A may be useful, this set up procedure is for the 660R but should be pretty close to what you need. I can't find a thing on the P602.

You may need to use the reset button to get the router/modem back to original configuration.

Users guide for the P660HW series.
http://www.zyxel.co.uk/web/support_...0060420160946,420060816160116,420080815092146

DSL:How to Set the Modem for Bridge Mode for Zyxel P 660R D1

 

[CommandoBob]

This bridge mode set up page for your ZyXEL P602HW-D1A may be useful, this set up procedure is for the 660R but should be pretty close to what you need. I can't find a thing on the P602.

You may need to use the reset button to get the router/modem back to original configuration.

Users guide for the P660HW series.
ZyXEL

DSL:How to Set the Modem for Bridge Mode for Zyxel P 660R D1

No, the problem is that i can't access the router page while i am IN bridge mode. But thanks for trying.

 

[chev65]

Ideally you would use a router and an AP/bridge rather than trying to turn your router into a bridge. To access my AP/bridge I just type in dlinkap into the URL of my brower rather than using an IP. It works best to let the router use DHCP and turn off DHCP on the AP/bridge.

I figured that the directions for setting up a bridge mode on your router might help you figure out how to access the router page in bridge mode?

 

[maiaibing]

Answer is here: http://www.sevenforums.com/network-...behind-router-2-minutes-flat.html#post2225361

Old thread but its high on the google list, so i thought it could be helpful to reference an easy solution to this problem.