Rolled back from W10 getting BSOD.

[Arator]

My computer was working fairly fine until recently. Upgraded to Windows 10 at the beginning of the month started getting BSOD so I rolled back to 7 thinking it might of been an issue with 10, but I've continued to get BSOD since rolling back.

I had a similar issue back in June that caused similar problems that turned out to be one of my SSDs dying. I'm unsure if it's this same case now or another issue.

 

[koolkat77]

Run Disk Check on your Hard Drive for file system errors and bad sectors on it.

 Hard Drive Diagnostics

• Double click and open my computer.
• Right click on desired drive and hit properties.
• Click on tools tab and Check now.

Read complete instructions on the tutorial: http://www.sevenforums.com/tutorials/433-disk-check.html

Other Tests:

 

• Upload a screenshot of your hard disk using Crystal Disk Info.
• Make a hard drive test from the hard drive manufacturers website.
• Test your Hard Drive with SeaTools.

Take memtest. Run for 8 passes and test each stick in a know good slot for an additional 6 passes.

• RAM - Test with Memtest86+

The goal is to test all the RAM sticks and all the motherboard slots.

Check your motherboard manual to ensure the RAM sticks are in the recommended motherboard slots. Some motherboards have very specific slots required for the number of RAM sticks installed.

If you get errors, stop the test and continue with the next step.

1. Remove all but one stick of RAM from your computer (this will be RAM stick #1), and run Memtest86 again, for 7 passes.

*Be sure to note the RAM stick, use a piece of tape with a number, and note the motherboard slot.
​

If this stick passes the test then go to step #3.

2. If RAM stick #1 has errors, repeat the test with RAM stick #2 in the same motherboard slot.

*If RAM stick #2 passes, this indicates that RAM stick #1 may be bad. If you want to be absolutely sure, re-test RAM stick #1 in another known good slot.
​

*If RAM stick #2 has errors, this indicates another possible bad RAM stick, a possible motherboard slot failure or inadequate settings.
​

3. Test the next stick of RAM (stick #2) in the next motherboard slot.

*If this RAM stick has errors repeat step #2 using a known good stick if possible, or another stick.
​

*If this RAM stick has no errors and both sticks failed in slot#1, test RAM stick #1 in this slot.
​

4. If you find a stick that passes the test, test it in all the other motherboard slots.

If Part 2 testing shows errors, and all tests in Part 3 show errors, you will need to test the RAM sticks in another computer and/or test other RAM in your computer to identify the problem.

In this way, you can identify whether it is a bad stick of RAM, a bad motherboard, or incompatibility between the sticks.

   Information

Errors are sometimes found after 8 passes.

   Tip

Memtest should be done overnight.