- Local time
- 6:26 AM
- Messages
- 50,634
There is always risk involved in disassembling a laptop to clean it properly, especially because the most important item to clean is the CPU heat sink which is often buried so deep you access it last with a hundred parts spread all over the table by then. I've never had a failure but came close, and there are always issues like a fingernail-size clamp holding keyboard ribbon cable that breaks. Just managing the screws is a job in itself.
This is the reason its too expensive to have a shop do it, so its best to view it as a learning experience on a PC you are fully willing to sacrifice if all does not go well.
Short of re-pasting the CPU there are lesser cleaning tasks that can be done less invasively:
How To Dismantle, Clean and Repair an HP Laptop - Tim Trott
How To Clean Dust From Your Laptop - YouTube
Cleaning Your Laptop Cooling System
How to clean your laptop & stop it from overheating (Dell Inspiron)
This is the reason its too expensive to have a shop do it, so its best to view it as a learning experience on a PC you are fully willing to sacrifice if all does not go well.
Short of re-pasting the CPU there are lesser cleaning tasks that can be done less invasively:
How To Dismantle, Clean and Repair an HP Laptop - Tim Trott
How To Clean Dust From Your Laptop - YouTube
Cleaning Your Laptop Cooling System
How to clean your laptop & stop it from overheating (Dell Inspiron)
Last edited: