El Franko
New member
- Local time
- 7:33 AM
- Messages
- 1
Hi there - installed the RC when it came out, and today I used the free version of EASEUS to add one partition. After the partition change, it rebooted and I got an error that said Windows detected some kind of problem (like a moron I didn't write the error # down) and that I needed to repair using the installation disk.
So I stuck in the 7 DVD and clicked on repair, which was the recommended option. Only other option was to start normally. After a few seconds of scanning it restarted, and I got the same error message, and again, the option to repair or to start normally. This time I started normally and 7 loaded fine. New partition was there and it seems to be working ok.
On the EASEUS forums, they said it should be compatible with 7. But they're not testing with the beta, and I guess the RC but I didn't read that.
Am I asking for trouble if I don't clean install 7 again, and just keep using the new partition?
So I stuck in the 7 DVD and clicked on repair, which was the recommended option. Only other option was to start normally. After a few seconds of scanning it restarted, and I got the same error message, and again, the option to repair or to start normally. This time I started normally and 7 loaded fine. New partition was there and it seems to be working ok.
On the EASEUS forums, they said it should be compatible with 7. But they're not testing with the beta, and I guess the RC but I didn't read that.
Am I asking for trouble if I don't clean install 7 again, and just keep using the new partition?
My Computer
- OS
- 7 RC