BSOD's Again...

[smarteyeball]

If your feeling game, you could try using Windbg to try and read the crash dump yourself. Amongst all the inital goobledy-gook, it will sometimes tell you which driver is the culprit.

http://www.microsoft.com/whdc/devtools/debugging/default.mspx

I wouldn't worry too much about the symbols component.

Your crash dump will be at:
C:\Windows\MEMORY.DMP

Run Windbg as admin.

 

[Orbital Shark]

Yes please do. And thanx

 

[jeutie]

One more question though, Nvidia doesn't directly give me what I am searching for,
the nVidia Storage Manager driver would be part of the nforce?

So I'll install the latest nforce drivers... And I'll keep you updated,
Unfortunately I won't be at home tomorrow so I cannot test it out...

I'll post if it has worked on Wednesday (please keep it open mods ^^)

 

[baarod]

One more question though, Nvidia doesn't directly give me what I am searching for,
the nVidia Storage Manager driver would be part of the nforce?

Yes it's part of nForce drivers.

 

[jeutie]

Installing newest drivers now ^^

 

[jfar]

My Bios when I flashed it was straight forward ,just open the the downloaded Bios and follow the instructions.

 

[jeutie]

So, I installed the drivers & I'm off to bed now,
Have a busy day tomorrow, But if it goes wrong again on Wednesday,
I'll flash my bios & see if that helps...

I'll keep you guys updated!
*update*

I waked up early today, and I was really excited to see that the pc booted without a problem.
Now I do not want to jump ahead of the situation, I had 'good' boots before,
So I guess I'll see the final result tomorrow.
Pretty frustrating if you got to wait a whole day before you can test ^^

I have a feeling that it will work now,
Thanks all of you!

 

[jeutie]

Excuse me for bumping this by double-posting,
But, I have important news...

The pc gave the error again today.
I flashed my bios to the latest version
Installed the new driver of nforce,

Yesterday it went well...
Today I had the error again.
Now I am going to install the latest 64bit build I found (7068)

I would wait for the RC normally, but well... cba atm
I want to fix this :huh:

Even though, Many thanks to all people providing possible solutions,
I gave you all some rep

 

[Mark]

Build 7077 x86 is out now on the Bay and Small Nova and some are saying that the official RC1 will be released in a couple of days

 

[jeutie]

Saw that, but due the problem is still existing I'll reset my pc this night with what I have, If there are any more suggestions I'll be happy to hear about them

 

[jfar]

Hi,did you open the PC for anything recently,like to change anything ,

 

[jeutie]

To change anything? no...
But I did open it up today to see if all the wires were still aright (which they were) and to clean out dust.

 

[jfar]

Ok just check that everything is seated properly,like the ram and the graphics card etc,with the power off of course,meaning nothing loose.

 

[whoosh]

Got me flumuxed > Would have suggested a roll back but you proberly have tried that . If its hardware related hard to fathom from this end . Good luck with your problem and have you tried a frsh install ?

 

[jeutie]

@ jfar, Yes everything was fine inside

@ Whoosh, I did try many fresh installs,
(Did one today aswell)

It's very annoying when I can only see the result at the first boot...
But I'll see tomorrow if the new build did any good

Vista isn't a solution either, cause vista gives BSOD's & w7 gives error's @ the same first boot o the day