partition problem

[samyuth]

please help me to create 1 please

 

[AddRAM]

I`ve told you what to do.

Just click next, you can use Partition Wizard to work on partitions after you install windows.



Ahhh, now I see the note saying Windows can not be installed to this disk. That`s the problem.

Did you have Windows 7 installed before ?

 

[samyuth]

any solution pease help me im so thank full

 

[samyuth]

yes

 

[AddRAM]

I need you to click on show details in that picture,(post #20) then post a picture of what that says for me.

 

[samyuth]

here is the picture

 

[gregrocker]

Diskpart failed because you spelled "partition" wrong. You must be precise and double-check your work in all steps here.

Now start at the top and without skipping any work through the steps to Troubleshoot Windows 7 Installation Failures - Windows 7 Help Forums.

After defining an Active partition using Diskpart if it still fails then test your hard drive with the maker's HD Diagnostic extended CD scan, followed by a Disk Check from the disk System Recovery Options Command Line, run on the full disk partition you created in the Failure steps.

Report back results including verbatim error messages and the step in which they occurred.

Once installed activate with the Product Key on your COA sticker. If in doubt about the disk you have be sure to make another one from that step in tutorial.

 

[AddRAM]

Was Windows 7 already on this disk ?

You didn`t answer me.

OMG Greg, I didn`t notice that, good eyes.

I would also run the clean command on the drive before you create the partition.

 

[samyuth]

add ram im on touchpad i dont get u r answer quick sry and i had installed with this cd 2or 3 times

 

[samyuth]

im trying now gregrocker idea.... be right back thx for rply guys thank u very much

 

[AddRAM]

No, I asked if Windows 7 was already installed on this hard drive in this computer.

 

[samyuth]

im now here i have a mistake should i restart my laptop

 

[samyuth]

or can i open nos command prompt?

 

[samyuth]

yes wn7 wAS BT NOW NOW

 

[samyuth]

its working

 

[AddRAM]

I cant read it, post 32, restart the install, did you run diskpart ? Did it work ?

 

[samyuth]

it wont help

 

[samyuth]

not work get error message

 

[AddRAM]

What won`t help ?

 

[samyuth]

yes i run the diskpart but it wont work i trust u that u can help me guys pleas just try to help