Solved Possible PSU problem?

[petko131]

I have noticed that when i launch speedfan 4.47 my -12v line is -16.97?!?!?!?!?!?!?!?
I am sure that is not good, so I am asking fore some advice? What can i do, or should i replace the PSU with a new one?

LC-Power LC6480S Scorpio-480W

 

[ignatzatsonic]

I wouldn't assume Speedfan is correct.

I'd give it more creedence if I knew that Speedfan previously showed some other value closer to 12.

But I'd test by some other means regardless.

 

[petko131]

well thats what i thought too... I'm currently browsing for some more reliable PSU checking program...

 

[mrmah]

Try some other softwares like (Open Hardware Monitor) and check if it will give the same readings as speedfan

 

[Layback Bear]

I trust this program.
Speccy - System Information - Free Download

 

[petko131]

It doesn't show the -12v line, ore i don't know to use the program properly

 

[Dwarf]

Don't worry about that. The -12V line was only used on very old motherboards with ISA expansion slots. Some PSUs don't even supply this voltage, and the pin on the 20/24 pin ATX main connector where this voltage would be found is often not wired to the PSU.

 

[petko131]

I like speccy here is my print screen preview

 

[petko131]

Thanks a lot guys for helping me out, I really appreciate it

 

[Dwarf]

Your voltages look fine to me. As I stated above, the negative voltages (-12V and -5V) were only used with the old ISA expansion slots (some add-on cards required these voltages), and are not used in modern computers.

 

[petko131]

Glad to her that because i was a little worried about this :shock:
But now it's ok