Windows 7 problem Minecraft freeze

[ToxicXGL]

After loading minecraft and playing for a few minuets trying to close it minecraft freezes up the entire computer even task manager and then we must shut the computer off by the main power and after a few minuets of freezing it comes back to normal what is the problem?

 

[writhziden]

Please provide us with your Event Viewer administrative logs by following these steps:

1. Click Start Menu
2. Type eventvwr into Search programs and files (do not hit enter)
3. Right click eventvwr.exe and click Run as administrator
4. Expand Custom Views
5. Click Administrative Events
6. Right click Administrative Events
7. Save all Events in Custom View As...
8. Save them in a folder where you will remember which folder and save as Errors.evtx
9. Go to where you saved Errors.evtx
10. Right click Errors.evtx -> send to -> compressed (zipped) folder
11. Upload the .zip file here.

After starting up our computer we get mulitple freezes and after about 10 mins of this there is a total freeze and this message pops up:
the instruction at 0x0000000007628eddf refereed memory at 0x0000000076250e20 The required data was not placed into memory be occuer of I/O from of 0x000000e.


What does this mean and how can we fix this

Please follow the http://www.sevenforums.com/crashes-debugging/96879-blue-screen-death-bsod-posting-instructions.html to provide us with the crash report for this crash. This will allow us to give informed troubleshooting steps for the problems you are experiencing.

I have asked that your threads be merged by one of our administrators.

 

[ToxicXGL]

After starting up our computer we get mulitple freezes and after about 10 mins of this there is a total freeze and this message pops up:
the instruction at 0x0000000007628eddf refereed memory at 0x0000000076250e20 The required data was not placed into memory be occuer of I/O from of 0x000000e.


What does this mean and how can we fix this




ok here is the file

 

[writhziden]

You are receiving the following message:

The file system structure on the disk is corrupt and unusable. Please run the chkdsk utility on the volume C:.

Run http://www.sevenforums.com/tutorials/433-disk-check.html with both boxes checked for HDDs and with Automatically fix file system errors checked for SSDs.

 

[ToxicXGL]

ok so after following the disk check steps i restarted it so i could check the desk thing and this showed up

Should I continue or restart?

 

[writhziden]

Try the following steps to see if you can get the disk check to run. Your hard disk has a lot of problems at the moment and really needs to run the check to recover bad sectors.

1. Go into your BIOS and load default settings to clear the CMOS memory.
2. Save Settings and exit the BIOS.
3. Shut down and turn off the computer.
4. Unplug the computer from the wall or surge protector (then remove the battery if it is a laptop).
5. Hold down the power button for 30 seconds. This closes the circuit and ensures all power from components is drained to clear the software connections between the BIOS and hardware and clear any corruption in the temporary memory.
6. (If it is a laptop, plug the battery back into the laptop and then) Plug the computer back into the wall.
7. Turn it on to reinitialize the software connections between the BIOS and hardware, and post back your results.

Also, do you have a Windows 7 installation DVD or repair disc?

 

[ToxicXGL]

K um where is the bio cause when I press a key to continue it just says the same thing over again

K well I did a system diagnostic and it says error code bioHD-2 no drives detected

Out computer doesn't accept repair disks should I try a system recovery

 

[writhziden]

You can get into the BIOS by turning the computer off, and then when it turns on, immediately start tapping F2, F10, DEL. Try one key, turn off the computer, then try a different key.

What is your motherboard or vendor (DELL, HP, GATEWAY, etc)?

 

[ToxicXGL]

Uh well our computer is a HP pavilion our mother board may be a PEGATRON im not sure

 

[writhziden]

For HP, F10 should start the BIOS. Tap F10 immediately after turning on the computer. You may have to tap it multiple times before the BIOS shows up. Then go to the exit section and select Load Setup Defaults. Save and Exit. Then do the other steps I outlined. Hopefully that will allow the computer to see the drive.

 

[ToxicXGL]

Says the same thing

 

[writhziden]

Were you able to get into the BIOS? Does the hard disk show up listed in the BIOS as a device?

 

[ToxicXGL]

I think so is their a separate tab for bios? On the main page their is a thing called bios revision but it's grey. Thier are 4 tabs in my setup: Main Advance Power Boot and Exit

 

[writhziden]

In Main, you should see a screen that looks like this: View attachment 196954

1st Drive and/or 2nd Drive should have your hard disk listed. Do either have a device associated with them?

 

[ToxicXGL]

Ok so I have drives 1-4 they say none, and my bios is 5.13

 

[writhziden]

Sounds like your hard disk failed... You may have to take it to a repair shop to see if they can get any important data off for you, or if it is still under warranty, send it to HP for repairs and a replacement drive. Ask HP if they can recover the data for you. I noticed your computer has been having problems with the drive since December.

 

[ToxicXGL]

Dang it warrentys up will we need to buy a new hard drive? and December of what year?

 

[writhziden]

Yeah, you will need a new hard drive.

December, 2011. Two months ago. I do not know how long the problem has actually been around because your logs only go back to mid December, but the problem was definitely present at that time.

I should also warn that I am not 100% sure the hard drive has failed. It may be the connection to the motherboard that failed. Your problems started due to IDE reads failing, which could be a connection issue. That connection issue may have resulted in corruptions on the hard disk, and either the connection has now failed completely or the hard drive has.

Here are the errors from December 9-11, 2011:

Event 11, Disk

The driver detected a controller error on \Device\Harddisk1\DR1.

Event 57, NTFS

The system failed to flush data to the transaction log. Corruption may occur.

Event 51, Disk

An error was detected on device \Device\Harddisk1\DR1 during a paging operation.

Event 11, atapi

The driver detected a controller error on \Device\Ide\IdePort0.

Seems pretty likely it is the drive that failed and not the connection, but just wanted you to know that there is a small possibility it is connection related or motherboard related.

 

[ToxicXGL]

Also what do you think caused the hard drive to fail?

 

[writhziden]

I notice that you have a few hard shut downs (manual shut downs where you held the power button down for 5-10 seconds to cause the computer to turn off). These can cause hard disk errors to accumulate and they can damage the disk.