Computer takes a long time to turn on...

[linnemeyerhere]

Is that 30 minutes of waiting or constant wire plugging and unplugging.

 

[Rawad]

Is that 30 minutes of waiting or constant wire plugging and unplugging.

Yeah It's quite annoying though.

 

[linnemeyerhere]

The question was a one or the other, not yes or no.

 

[Rawad]

The question was a one or the other, not yes or no.

You can say both. Everytime it wouldn't power on I would start from step one.

 

[linnemeyerhere]

It sounds like a bad cable or connection, nothing else to me would make this happen. When you finally get a good boot have you updated and run your Anti Virus and done deep scans? Do that and then restart into safe mode and run the updated virus in a deep scan in safe mode.

 

[Rawad]

It sounds like a bad cable or connection, nothing else to me would make this happen. When you finally get a good boot have you updated and run your Anti Virus and done deep scans? Do that and then restart into safe mode and run the updated virus in a deep scan in safe mode.

I will do that very soon. Hopefully it would be able to start up , just like before.

 

[linnemeyerhere]

Start it and run scans also if you don't have Malware Bytes please down load it (free version) and run it. If anything comes up keep running them till clean. quarantined.

 

[Rawad]

Start it and run scans also if you don't have Malware Bytes please down load it (free version) and run it. If anything comes up keep running them till clean. quarantined.

Malwarebytes is the most useful antivirus I have ever used. No worries I already have it installed on my Computer.

 

[Rawad]

Here is the brand new video , this time I use another Monitor..
Acer M5100 Faling TO BOOT! - YouTube

 

[mohavepc]

Hello Raiden92:
From what you have posted in this thread and the videos on youtube it sounds like this machine only boots once in a while. Hardware issues and even Bios issues can be a PITA to figure out but steps must be taken in an orderly fashion and protection from static must be adhered to. If you don't already own one I would suggest an antistatic wrist strap. It is a cheap insurance against permanent damage to your components. Newegg.com - antistatic

Usually with a machine that will eventually boot there are two things that come to mind that I have had experiences with. 1) Memory 2) Memory. First try one stick of memory, then the other. I would suggest clearing the bios after each attempt. (With the system completely unplugged and wrist strap in place pull the bios battery for 30 seconds while holding in the power button) If you able to eventually boot into your bios I would suggest loading defaults and rebooting.

You have tried a different monitor with a separate vga cable so I doubt there is any future in going that root.

You can unplug the data and power leads from hard drives, dvd drives, unplug the front panel card reader (note which port it plugs into). and see if this beast boots to a os not found screen then we plug in the dvd drive, if it boots quickly to os not found, then plug in hard drive ect. each time rebooting. This will weed out any culprit hardware.

First and foremost be prepared to learn a lot about your hardware and have patients. when you find the moment it stops booting good you may indeed find the issue at hand. Also I would take a flashlight and inspect the Capacitors on the Motherboard. look for any bulging, leakage, swelling. Leaking and Swollen Capacitors on Motherboards and Power Boards - YouTube if any look like these be prepared to replace the motherboard or get real good at soldering real fast.

I have added my twenty cents (inflation don't you know) and hopefully you can find some help there. If you don't understand a step just ask and I am sure someone here if not myself will be able to explain.

Good luck and have a good day.

 

[Rawad]

Hello Raiden92:
From what you have posted in this thread and the videos on youtube it sounds like this machine only boots once in a while. Hardware issues and even Bios issues can be a PITA to figure out but steps must be taken in an orderly fashion and protection from static must be adhered to. If you don't already own one I would suggest an antistatic wrist strap. It is a cheap insurance against permanent damage to your components. Newegg.com - antistatic

Usually with a machine that will eventually boot there are two things that come to mind that I have had experiences with. 1) Memory 2) Memory. First try one stick of memory, then the other. I would suggest clearing the bios after each attempt. (With the system completely unplugged and wrist strap in place pull the bios battery for 30 seconds while holding in the power button) If you able to eventually boot into your bios I would suggest loading defaults and rebooting.

You have tried a different monitor with a separate vga cable so I doubt there is any future in going that root.

You can unplug the data and power leads from hard drives, dvd drives, unplug the front panel card reader (note which port it plugs into). and see if this beast boots to a os not found screen then we plug in the dvd drive, if it boots quickly to os not found, then plug in hard drive ect. each time rebooting. This will weed out any culprit hardware.

First and foremost be prepared to learn a lot about your hardware and have patients. when you find the moment it stops booting good you may indeed find the issue at hand. Also I would take a flashlight and inspect the Capacitors on the Motherboard. look for any bulging, leakage, swelling. Leaking and Swollen Capacitors on Motherboards and Power Boards - YouTube if any look like these be prepared to replace the motherboard or get real good at soldering real fast.

I have added my twenty cents (inflation don't you know) and hopefully you can find some help there. If you don't understand a step just ask and I am sure someone here if not myself will be able to explain.

Good luck and have a good day.

If that's the case , then I have no problem waiting till I come back from vacation or even purchasing a new Tower.

 

[Rawad]

I notice while watching this video that there may be a lot of dust in the ram area so I have to clean it up. I don't have a brush with me. What would you suggest I use?

easy steps for fixing "No display pc" - YouTube

 

[linnemeyerhere]

Just the compressed air and please remove the modules and blast those slots as well the re-install and make sure you hear and see the end latches latch.

 

[Rawad]

Just the compressed air and please remove the modules and blast those slots as well the re-install and make sure you hear and see the end latches latch.

What do you mean modules, Sorry don't have much knowledge from the inside of a computer, but I ma enjoying learning.

 

[linnemeyerhere]

Ram sticks are also known as modules.

 

[Rawad]

Ram sticks are also known as modules.

EDIT: I will spray both ram sticks as well the ram slots with the compressed gas. While holding the ram sticks do I spry the compressed gas?, Is there a specific way because I don't want to mess up my computer.

 

[linnemeyerhere]

Hold the ram by the ends and I seriously doubt they need cleaning, just spray the slots and as advised only insert one stick in the slot closet to the CPU and try to boot. If no go then remove that ram and install the other stick in the same slot and report back what happens?

 

[Rawad]

Hold the ram by the ends and I seriously doubt they need cleaning, just spray the slots and as advised only insert one stick in the slot closet to the CPU and try to boot. If no go then remove that ram and install the other stick in the same slot and report back what happens?

Alright man, I will do that and let you know what happens.

 

[Rawad]

Hold the ram by the ends and I seriously doubt they need cleaning, just spray the slots and as advised only insert one stick in the slot closet to the CPU and try to boot. If no go then remove that ram and install the other stick in the same slot and report back what happens?

Same results, I accidentally got to close while spraying the ram slots that compressed gas came out. I honestly have no idea what the problem with my computer can be I literally tried everything I can think of. You guys also suggested things and they didn't work . This Computer doesn't want to live no more.

 

[linnemeyerhere]

Yeah it's not a pretty situation. How about you leave the rig on once booted up?