BSOD during Power on, error 0x00000019 & 0x000000C2

[GavinLiao]

My system happened BSOD 2 times with different error code. Information was attached, please help!

 

[Golden]

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck C2, {7, 109b, 50012, fffffa80073b93d0}

GetPointerFromAddress: unable to read from fffff800032fb100
GetUlongFromAddress: unable to read from fffff800032fb1c0
Probably caused by : ndis.sys ( ndis!nullDeleteFilter+15 )

Followup: MachineOwner
---------

Please do the following:

Run Driver Verifier for 24 hours or the occurrence of the next crash, whichever is earlier.
http://www.sevenforums.com/tutorials/101379-driver-verifier-enable-disable.html

Driver Verifier will cause your computer to run very sluggishly - this is normal. What it is trying to do is force your system to BSOD and isolate the offending driver/s. When it does, reboot, disable driver verifier, reboot as normal and upload the new dmp file/s here.

I recommend creating a system restore point before turning on driver verifier:
http://www.sevenforums.com/tutorials/697-system-restore-point-create.html

If your system fails to boot to desktop once driver verifier is enabled, turn it off by booting into Safe Mode:
http://www.sevenforums.com/tutorials/69585-safe-mode.html

 

[GavinLiao]

Thank you, it seems a good way to verify the problem, I'll try it later~