BSOD While doing anything for 10+ minutes STOP Error 0x00000050

[Massaddict]

Hello, I have been posting here for the past 2 weeks and have not found a 100% clear answer for my problem. First off, my computer ran fine for about 5 hours after a 10-day vacation and just an hour ago I got a BSOD Error 0x00000050. I have ran Memtest and it shows a lot of red layers/lines, but it took about an hour to get 1 pass and I got a whole list of red lines with numbers. I'd be glad to do the memtest in which I take test 1 RAM stick at a time tomorrow. When I startup after the BSOD, I get an error from my AMD Catalyst Manager saying my display drivers need to be reinstalled. My device manager shows that my AMD Radeon 7800 HD Series and Intel HD Graphics 3000 have a yellow triangle and an exclamation mark. My build is exactly a month old today and it really sucks to have this happen to me because I spent all my summer job money on this build. If reformatting or purchasing a new part fixes this and it is 100% that it will fix this I would be willing to do it. Right now I am in Safe Mode with Networking and I have provided you guys with my Seven Forums Files. Thank you for all the awesome support from this forum!

 

[yowanvista]

I have ran Memtest and it shows a lot of red layers/lines

That indicates a defect in your RAM stick(s). You should test each one at a time to identify the problematic one.

Your AVG software is also involved, I would recommend removing it.

BugCheck 19, {3, fffffa800789c5e0, fffffa800789c5e0, fffff8800789c5e0}

Unable to load image \SystemRoot\system32\DRIVERS\avgidsfiltera.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for avgidsfiltera.sys
*** ERROR: Module load completed but symbols could not be loaded for avgidsfiltera.sys
Probably caused by : Pool_Corruption ( nt!ExDeferredFreePool+a53 )

 

[Massaddict]

Do you have any specific steps on testing them seperately? Using a single stick of RAM would be the first slot right?

 

[yowanvista]

Do you have any specific steps on testing them seperately? Using a single stick of RAM would be the first slot right?

Have only one stick of RAM plugged in at a time in any slot then run Memtest, repeat the procedure for all sticks.