Frequent BSOD after fresh Install on new SSD BPC1:C04FBCD0

[sagrawal9]

Folks,

First thanks for the forum and all working and helping here.
I have a Lenovo T400 laptop, where I did a fresh install of Win 7 ultimate on new SSD. After trial and errors, the install was successful and I have been using it consistently for the last three months. However once in a while, the computer will display BSOD.
I have noticed this happens , when sometimes Adobe update happens.. not sure whether this is true or not. or When IE is very busy.. just some observation.
Today I put on USB drive and the system tried to install the driver and then BSOD again.
The dump zip is included here and looking for some help please.
Thanks.

 

[Boozad]

Welcome to 7F.

The first thing I'd like you to try is run a diagnostic check on your RAM to rule out a faulty module.

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck 7A, {c04e5d98, c000000e, bbae820, 9cbb3154}

Probably caused by : memory_corruption ( nt!MiWaitForInPageComplete+302 )

Followup: MachineOwner

Download and run MemTest86+ to test your RAM.

   Note

Run MemTest86+ for at least 8 passes. Ideally set it off before you go to bed and leave it overnight, we're looking for zero errors here. A single error will show something's going bad with your RAM.

Report back with the results.

 

[HarriePateman]

Welcome to SevenForums,

The BSOD reports a memory corruption.

[COLOR=Red]Probably caused by : memory_corruption[/COLOR]

Test your RAM modules for possible errors.

How to Test and Diagnose RAM Issues with Memtest86+​

I would recommend to leave this running overnight as this can take some time.

 

[HarriePateman]

Welcome to 7F.

The first thing I'd like you to try is run a diagnostic check on your RAM to rule out a faulty module.

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck 7A, {c04e5d98, c000000e, bbae820, 9cbb3154}

Probably caused by : memory_corruption ( nt!MiWaitForInPageComplete+302 )

Followup: MachineOwner

Download and run MemTest86+ to test your RAM.

   Note

Run MemTest86+ for at least 8 passes. Ideally set it off before you go to bed and leave it overnight, we're looking for zero errors here. A single error will show something's going bad with your RAM.

Report back with the results.

Sorry mate, we both posted at the same time.

 

[Boozad]

Sorry mate, we both posted at the same time.

Not a problem Harrie.