ntoskrnl.exe bsod

[atzp5]

I have been receiving BSOD's for a while now. I went ahead and uninstalled Panda Security (one BSOD pointed to it) and all of the files along with it . Ran memtest86 and on the 9th pass it had one error. Does that mean it's a faulty module? Can you guys see if there's anything else I should be doing? I really appreciate the help.


Thanks
Andrew

 

[Arc]

BugCheck 1E, {ffffffffc0000005, fffff80002c83945, 0, ffffffffffffffff}

Probably caused by : ntkrnlmp.exe ( nt!ExpInterlockedPopEntrySListFault16+0 )

Followup: MachineOwner
---------

BugCheck 1000007E, {ffffffffc0000005, fffff80002c9cf5c, fffff880009a99d8, fffff880009a9230}

Probably caused by : memory_corruption ( nt!MmZeroPageThread+883 )

Followup: MachineOwner
---------

BugCheck 3B, {c0000005, fffff80002c88dc5, fffff880027fc9e0, 0}

Probably caused by : ntkrnlmp.exe ( nt!ExpInterlockedPopEntrySListFault16+0 )

Followup: MachineOwner
---------

Test your RAM modules for possible errors.

How to Test and Diagnose RAM Issues with Memtest86+
​

Run memtest86+ for at least 8 consecutive passes.

If it start showing errors/red lines, stop testing. A single error is enough to determine that something is going bad there.

It it does not show any error, enable Driver Verifier to monitor the drivers.

Driver Verifier - Enable and Disable
​

Run Driver Verifier for 24 hours or the occurrence of the next crash, whichever is earlier.

   Information

Why Driver Verifier:
It puts a stress on the drivers, ans so it makes the unstable drivers crash. Hopefully the driver that crashes is recorded in the memory dump.

How Can we know that DV is enabled:
It will make the system bit of slow, laggy.

   Warning

Before enabling DV, make it sure that you have earlier System restore points made in your computer. You can check it easily by using CCleaner looking at Tools > System Restore.

If there is no points, make a System Restore Point manually before enabling DV.

   Tip

• If you fail to get on the Desktop because of DV, Boot into Advanced Boot Options > Safe mode. Disable DV there. Now boot normally again, and try following the instruction of enabling DV again.
• If you cannot boot in Safe mode too, do a System Restore to a point you made earlier.

Let us know the results, with the subsequent crash dumps, if any.

HP OEM on Asus
​